The command "ip route 192.168.24.64 255.255.255.192 192.168.8.2 100" was configured on a router named TK1. No routing protocols or other static routes are configured on the Corporate router yet.Based on this information, which statement is true about this

Router R1 exists in an Enterprise that uses EIGRP as its routing protocol. The show ip route command output on router R1 lists the following phrase: "Gateway of last resort is 1.1.1.1 to network 2.0.0.0".Whic h of the following is most likely to have caused this output to occur on R1?（）

A. R1 has been configured with an ip default- network 2.0.0.0 command.

B. R1 has been configured with an ip route 0.0.0.0 0.0.0.0 1.1.1.1 command.

C. R1 has been configured with an ip route 2.0.0.0 255.0.0.0 1.1.1.1 command.

D. Another router has been configured with an ip default - network 2.0.0.0 command.

E. Another router has been configured with an ip route 2.0.0.0 255.0.0.0 1.1.1.1 command.

A router leams about a remote network from EIGRP.OSPF. and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network?（）

A. The router will use the static route.

B. The router will use the OSPF route.

C. The route will use the EIGRP route.

D. The router will load balance and use all three routes.

Router R1 has been configured with the redistribute ospf 1 route - map fred command under router eigrp 1. The route map named fred needs to be configured to match routes to d etermine which routes are redistributed into EIGRP.Which of the following answers lists an item that cannot be matched by route map fred?（）

A. Subnet number

B. Next - hop router IP address of the route

C. Whether the route is an E1 or E2 route

D. The ro ute‘s tag

E. The number of router hops between the router and the subnet

A router learns about a remote network from EIGRP, OSPF, and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network（）。

A.The router will use the static route.

B.The router will use the OSPF route.

C.The router will use the EIGRP route.

D.The router will load balance and use all three routes.

A. It is a route to be used when the routing protocol fails.

B. It is a route configured by an ISP that sends traffic into a corporate network.

C. It is a route used when a packet is destined for a remote network that is not listed in the routing table.

D. It is a route manually configured for a specific remote network for which a routing protocol is not configured.

E. It is used to send traffic to a stub network.

A.No dynamic interior routing protocol can summarize as shown

B.Unless configured otherwise, EIGRP would automatically summa rize the prefixes as shown in the exhibit

C.With this IP addressing scheme, EIGRP can be manually configured to summarize prefixes at the specified summarization points

D.The IP address design lends itself to OSPF Each summarizing router would be an ABR, summarizing to the next area in the address hierarchy

The command "ip route 192.168.24.64 255.255.255.192 192.168.8.2 100" was configured on a router named TK1. No routing protocols or other static routes are configured on the Corporate router yet.Based on this information, which statement is true about this command?（）

A. This command sets a gateway of last resort for the TK1 router.

B. The number 100 indicates the number of hops to the destination network.

C. The interface with IP address 192.168.8.2 is on the TK1 router.

D. The command creates a static route for all IP traffic with the source address 192.168.24.64.

E. Packets destined for host 192.168.24.124 will be sent to 192.168.8.2.

F. None of the above

A. The router must have one routing protocol configured, but configuration for both routing protocols is not necessary

B. The router must hav e at least one working link connected to each routing domain

C. The redistribute command must be configured under EIGRP to send the routes to OSPF

D. The redistribute command should be configured under OSPF to take routes from EIGRP into OSPF

A.When manual summarization is configured, the router immediately creates a route that points to null0 interface

B.Manual route summarization is configured in router configuration mode when the router is configured for EIGRP routing

C.Manual route summarization is configured on the interface

D.The ip summary - address eigrp command generates a default route with an administrative distance of 5

E.When manual summarization is configured, the summary route will use the metric of the largest specific metric of the summary routes

F.The ip summary - address eigrp command generates a default route with an administrative distance of 90

A.It establishes a static route to the 172.16.3.0 network.

B.It establishes a static route to the 192.168.2.0 network.

C.It configures the router to send any traffic for an unknown destination to the 172.16.3.0 network.

D.It configures the router to send any traffic for an unknown destination out the interface with the address 192.168.2.4.

E.It uses the default administrative distance.

F.It is a route that would be used last if other routes to the same destination exist.