While logged into a router, you wish to see the RIP routing updates in real time as they are sent and received. Which command would you issue to see these updates?（）A、Show ip protocolsB、Show ip route ripC、Debug ip ripD、Debug ip updatesE、Debug ip transacti

Refer to the exhibit. EIGRP has been configured on router D. Router C is performing mutual redistribution between EI GRP and OSPF. While verifying that the redistribution is functioning properly, you discover that while router C has all of the EIGRP routes in its routing table, router A does not have any routes from the EIGRP domain. What on router C may be the cause o f the problem?（）

A. The no auto - summary command needs to be added under router eigrp 1

B. The subnets keyword was not included in the redistribute command under router ospf 1

C. The metric specified for the redistributed EIGRP routes is too large; m aking the EIGRP routes unreachable by router A

D. The default - information originate command needs to be added under router ospf 1

E. The administrative distance of either OSPF or EIGRP must be changed so that EIGRP has a higher administrative distanc e than OSPF

While logged into a router you manually shut down the serial 0 interface using the "shutdown" interface configuration command. You then issue the "show interface serial 0" command in exec mode. What could you expect the status of the serial 0 interface to be?（）

A. Serial 0 is up, line protocol is up

B. Serial 0 is up, line protocol is down

C. Serial 0 is down, line protocol is down

D. Serial 0 is down, line protocol is up

E. Serial 0 is administratively down, line protocol is down

F. Serial 0 is administratively down, line protocol is up

You are logged into a router and wish to view the layer 3 information about your neighboring Cisco routers. What IOS command gives layer 3 information for of the directly connected router interfaces?

A. show ip links

B. show cdp neighbor

C. show cdp neighbor detail

D. show ip clients

E. show ip route

F. None of the above

A. The IP addresses of workstations allowed gain access to the router via an access list

B. Permanent name-to-address mappings created using the ip host command.

C. Temporary and permanent DNS entries.

D. The names of the routers created using the hostname command.

E. The length of time of users logged into the router, as well as the duration

While troubleshooting a network connectivity issue, you suspect that a router may be missing a route, or may be receiving bad routing information to a destination. What command should you issue to view the route that the router will use to reach a given destination?（）

A. ping

B. trace

C. show ip route

D. show interface

E. show cdp neighbors

A. Show ip protocols

B. Show ip route rip

C. Debug ip rip

D. Debug ip updates

E. Debug ip transactions

You use two user accounts for your computer: standard user and administrator. You log on to your computer as standard user but are unable to make advanced configuration changes. You need to make advanced configuration changes while you are logged on as a standard user.What should you do?（）

A.A

B.B

C.C

D.D

A.%

B.@

C.>

D.$

E.#