HSRP Benefits？

第1题：

HSRP has been configured between two Company devices.  Which of the following describe  reasons for deploying HSRP？ （）

• A、 HSRP provides redundancy and fault tolerance
• B、 HSRP allows one router to automatically assume the function of the second router if the second  router fails
• C、 HSRP allows one router to automatically assume the function of the second router if the second  router starts
• D、 HSRP provides redundancy and load balancing

第2题：

HSRP is being set up between two Company devices.  In what three states is it possible for an  HSRP router to be in？（）

• A、 Standby
• B、 Established
• C、 Active
• D、 Idle
• E、 Backup
• F、 Init

第3题：

第4题：

热备份路由（HSRP）的实现方法

第5题：

HSRP. Known as Hot Stanclby Router Protocol, is a Cisco proprietarv redundancy protocol . As an experienced network administrator, you are required to configure HSRP on a XYZ network. Which TWO of the following wii be available and shared between the routers configured with HSRP? （）(Choose two.)

• A、a shared single interface
• B、the ability to track serial interfaces
• C、UDP-based hello packets
• D、the impact of flapping links if timers are too low

第6题：

Hot Standby Router Protocol (HSRP) is able to provide network redundancy for IP networks. Concerning HSRP load sharing, which two descriptions make sense?（）

• A、It is achieved by using more than one HSRP group.
• B、It is done in regards to either round robin or weight basis.
• C、It is used to offload the active router in a certain HSRP group.
• D、The return traffic is influenced by HSRP load sharing configuration.
• E、Single group HSRP is used to achieve more efficient link utilization.

第7题：

During routine maintenance， G1/0/1 on DS1 was shutdown. All other interface were up. DS2 became the active HSRP device for Vlan101 as desired. However， after G1/0/1 on DS1 was reactivated. DS1 did not become the active HSRP device as desired.  What need to be done to make the group for Vlan101 function properly ？ （）

• A、 Enable preempt on DS1’s Vlan101 HSRP group
• B、 Disable preempt on DS1’s Vlan101 HSRP group
• C、 Decrease DS1’s priority value for Vlan101 HSRP group to a value that is less than priority value configured on DS2’s HSRP group for Vlan101
• D、 Decrease the decrement in the track command for DS1’s Vlan 101 HSRP group to a value less than the value in the track command for DS2’s Vlan 101 HSRP group.

第8题：

Which three statements about HSRP operation are true?（）

• A、The virtual IP address and virtual MA+K44C address are active on the HSRP Master router.
• B、The HSRP default timers are a 3 second hello interval and a 10 second dead interval.
• C、HSRP supports only clear-text authentication.
• D、The HSRP virtual IP address must be on a different subnet than the routers' interfaces on the same LAN.
• E、The HSRP virtual IP address must be the same as one of the router's interface addresses on the LAN.
• F、HSRP supports up to 255 groups per interface, enabling an administrative form of load balancing.

第9题：

HSRP state？

第10题：

You need to decide on the best router redundancy protocol to use in the Company network.  Which  two statements are true about HSRP， VRRP， and GLBP？（）

• A、 GLBP and VRRP allow for MD5 authentication， whereas HSRP does not.
• B、 HSRP allows for multiple upstream active links being simultaneously used， whereas GLBP  does not.
• C、 GLBP allows for router load balancing of traffic from a network segment without the different  host IP configurations required to achieve the same results with HSRP.
• D、 Unlike HSRP and VRRP， GLBP allows automatic selection and simultaneous use of multiple  available gateways.
• E、 GLBP allows for router load balancing of traffic from a network segment by utilizing the creation  of multiple standby groups.