You need to configure two Company routers for high availability. Which protocol enables a group of routers to form a single virtual router and use the real IP address of a router as the gateway address? ()
第1题:
A.HSRP
B.IRDP
C.ProxyARP
D.GLBP
E.VRRP
F.Noneoftheotheralternativesapply
第2题:
A. router(config-if)#ip address 142.8.2.1 subnet mask 255.255.252.0
B. router(config-if)#142.8.2.1 0.0.3.255
C. router(config-if)#ip address 142.8.2.1 255.255.252.0
D. router(config-if)#142.8.2.1 subnet mask 255.255.252.0
E. router(config-if)#ip address 142.8.2.1 0.0.3.255
F. router(config-if)#ip address 142.8.2.1 subnet mask /22
第3题:
A. Configure a non-unique address on the loopback interface for use by the PIM RP.
B. Configure MSDP with the unique address (router ID) as the local address of the peer.
C. Configure MSDP with the non-unique address (router ID) as the local address of the peer.
D. Configure a unique address on the loopback interface, used as the PIM RP.
第4题:
In GLBP, which router will respond to client ARP requests?()
第5题:
A.The virtual IP address and virtual MA+K44C address are active on the HSRP Master router.
B.The HSRP default timers are a 3 second hello interval and a 10 second dead interval.
C.HSRP supports only clear-text authentication.
D.The HSRP virtual IP address must be on a different subnet than the routers‘ interfaces on the same LAN.
E.The HSRP virtual IP address must be the same as one of the router‘s interface addresses on the LAN.
F.HSRP supports up to 255 groups per interface, enabling an administrative form of load balancing.
第6题:
A. Two switches are connected via a trunk. Both switches have been assigned an IP address, subnet mask, and default gateway. A ping is successful between the two switches. However, VLAN information is not passed from one switch to the other switch.
B. A router and a switch have been assigned an IP address, a subnet mask, and a default gateway. They are directly connected, but a ping between the two devices fails.
C. A router connects to another router through a serial interface. Both routers have been assigned an IP address, subnet mask, and default gateway. The routers are running RIP and the networks directly connected to the first router do not pass to the second router. However, a ping from one router to the serial interface of the directly connected neighboring router is successful.
D. A router connects to another router via a switch. Both routers and the switch have been assigned an IP address, subnet mask, and default gateway. Neither the routers nor the switch are able to ping one of the hosts that is directly to the switch.
第7题:
A. the IP address of the first Fast Ethernet interface
B. the IP address of the console management interface
C. the highest IP address among its active interfaces
D. the lowest IP address among its active interfaces
E. the priority value until a loopback interface is configured
第8题:
A. Define the virtual router IP address on both WXC devices.
B. Add a static route for the virtual router IP address on both WXC devices.
C. Define the physical IP address of each router on each respective WXC device.
D. Leave the default gateway field in the WXC device blank; it will automatically detect the active gateway address.
第9题:
A.The active virtual gateway will reply with one of four possible virtual MAC addresses.
B.All GLBP member routers will reply in round-robin fashion.
C.The active virtual gateway will reply with its own hardware MAC address.
D.The GLBP member routers will reply with one of four possible burned in hardware addresses
第10题:
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()