A router has two FastEthernet interfaces and needs to connect to four vlans in the local network.How can you accomplish this task,using the fewest physical interfaces and without decreasing networkper formance?()
第1题:
A. The first DHCP client to connect to the FastEthernet 0/1 interface will receive the IP address 10.10.0.1.
B. DHCP requests received on the FastEthernet 0/1 interface will be forwarded to 10.0.0.2.
C. The first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP a ddress 10.0.0.1
D. The first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP address 10.0.0.6.
E. Hosts connected to the FastEthernet0/1 interface will not receive DHCP replies from the router.
第2题:
A company has a small network,consisting of a single switch and a single router.The switch has been configured with two vlans,and route-on-a-stick is being configured on the router for inter-vlan routing.A trunk is configured to connect the switch to the router.What is the minimum number of router subinterfaces that are required for all the vlans to communicate?()
A. one
B. three
C. two
D. zero
第3题:
阅读路由器Router的部分配置信息,解释(5)~(7)处的命令,将答案填写在答题纸上相应的位置。
Router(config)interface fastEthernet1/0.1
Router(config-subif)encapsulation isl 11 (5)
Router(config-subif)ip addreSs 192.168.1.1 255.255.255.240 (6)
Router(config-subif)exit
Router(config)interface fastEthernet1/0.2
Router(config-subif)encapsulation isl 12
Router(config-subif)ip address 192.168.1.33 255.255.255.224
Router(config-subif)exit
Router(config)interface fastEthernet1/0.3
Router(config-subif)encapsulation isl 13
Router(config-subif)ip address 192.168.1.129 255.255.255.192
Router(config-subif)exit
Router(config)ip routing (7)
第4题:
A company has a Frame Relay WAN with one central - site router and 100 branch office routers. A partial mesh of PVCs exists: one PVC between the central site and each of t he 100 branch routers. All routers use point - to - point subinterfaces and one subnet per PVC. Which of the following is true about OSPF in this design?()
第5题:
A.Router1 has specific boot system command that instruct it to load IOS from TFTP server.
B.Router1 is acting as a TFTP server for other routers.
C.Router1 cannot locate a valid IOS image in flash memory.
D.Router1 defaulted to ROMMON mode and loaded the IOS image from a TFTP server.
E.Cisco routers will first attempt to load a image from TFTP for management purposes.
第6题:
A. This is the designated router (DR) on the FastEthernet 0/0 link.
B. The output was generated by the show ip interface c ommand.
C. The router was configured with the commands:r outer ospf 1 network 172.16.6.0 0.0.0.255 area 1
D. The IP address of the backup designated router (BDR) is FE80::205:5FFF:FED3:5808.
E. Interface FastEthernet 0/0 was configured with the ipv6 o spf 1 area 1 command.
F. OSPF version 2 has been enabled to support IPv6.
第7题:
A. SW1#show swithport port-security interface FastEthernet 0/12
B. SW1# show swithport port-secure interface FastEthernet 0/12
C. SW1# show port-secure interface FastEthernet 0/12
D. SW1#show running-config
E. SW1#show port-security interface FastEthernet 0/12
第8题:
A. You can reach other Level 2 routers.
B. It can reach at least one other defined area.
C. The router is reachable by at least two ES-IS nodes.
D. It has at least one enabled reachable prefix with a valid metric defined.
第9题:
Which two commands correctly verify whether port security has been configured on port FastEthernet0/12 on a switch?()
第10题:
A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router,as the routing protocol for the network.Which statement about thisnetwork is true?()