During startup, the router displays the following error message: boot: cannot open "flash:" What will the router do next?()
第1题:
You need to upgrade the IOS of an existing router on your network. The new IOS image is located on a TFTP server that you have set up within the network. What command should you issue in order to download the new IOS version?()
A. Router# copy tftp flash
B. Router# copy flash run
C. Router(config)# restore flash
D. Router(config)# repair flash
E. Router#copy flash tftp
F. Router# copy start flash
第2题:
A. Flash,TFTP server,ROM
B. Flash,NVRAM,ROM
C. ROM,NVRAM,TFTP server
D. NVRAM,TFTP server,ROM
E. TFTP server,Flash,NVRAM
第3题:
During startup, router VE1 displays the following error message:
boot: cannot open "flash:"
What will VE1 do next?
A. It will attempt to locate the configuration file from a TFTP server. If this fails, it will initiate the setup dialog.
B. It will attempt to locate the IOS from a TFTP server. If this fails, it will load a limited IOS from ROM.
C. It will attempt to locate the configuration file from a TFTP server. If this fails, it will load a limited configuration from ROM.
D. Because of damaged flash memory, the router will fail the POST.
E. It will attempt to locate the IOS from a TFTP server. If this fails, it will initiate the setup dialog.
F. None of the above
第4题:
A.Flash,TFTPserver,ROM
B.Flash,NVRAM,ROM
C.ROM,NVRAM,TFTP server
D.NVRAM,TFTP server,ROM
E.TFTP server,Flash,NVRAM
第5题:
A.It checks the configuration register
B.It attempts to boot from a TFTP server
C.It loads the first image file in flash memory
D.It inspects the configuration file in NVRAM for boot instructions
第6题:
A. The new IOS image is too large for the router flash memory.
B. The TFTP server is unreachable from the router.
C. The new IOS image is not correct for this router platform.
D. The IOS image on the TFTP server is corrupt.
E. There is not enough disk space on the TFTP server for the IOS image.
第7题:
A.Router1 has specific boot system command that instruct it to load IOS from TFTP server.
B.Router1 is acting as a TFTP server for other routers.
C.Router1 cannot locate a valid IOS image in flash memory.
D.Router1 defaulted to ROMMON mode and loaded the IOS image from a TFTP server.
E.Cisco routers will first attempt to load a image from TFTP for management purposes.
第8题:
During the boot sequence, a Ezonexam 2800 series router needs to locate and load an operating system. What is the default order the router uses to find an operating system?
A.ROM, TFTP server, Flash
B.Flash, TFTP server, ROM
C.Flash, NVRAM, TFTP server
D.Flash, ROM, TFTP server
E.Flash, TFTP server, RAM
第9题:
A.It checks the configuration register
B.It attempts to boot from a TFTP server
C.It loads the first image file in flash memory
D.It inspects the configuration file in NVRAM for boot instructions
第10题:
A.Because of damaged flash memory, the router will fail the POST.
B.It will attempt to locate the IOS from a TFTP server. If this fails, it will initiate the setup dialog.
C.It will attempt to locate the IOS from a TFTP server. If this fails, it will load a limited IOS from ROM.
D.It will attempt to locate the configuration file from a TFTP server. If this fails, it will initiate the setup dialog.
E.It will attempt to locate the configuration file from a TFTP server. If this fails, it will load a limited configuration from ROM.