IBM认证考试
An administrator issued a command to update thefirmware of an Ethernet adapter on a partitioned system, but received an error. What is the most likely cause of the problem?（）A、The adapter must be taken offline prior to the firmware update.B、The system ha
题目
An administrator issued a command to update thefirmware of an Ethernet adapter on a partitioned system, but received an error. What is the most likely cause of the problem?（）
- A、The adapter must be taken offline prior to the firmware update.
- B、The system has not been rebooted since the adapter was added to the LPAR.
- C、The adapter must be assigned to the service partition prior to updating the firmware.
- D、The adapter must be dynamically removed from the LPAR prior to updating thefirmware.
相似问题和答案
第1题：
An administrator is troubleshooting a problem on an application server, but has not determined the cause of the problem and is not able to replicate the problem. Which of the following should the administrator do prior to escalating the issue?（）
- A、Gather information from users.
- B、Reboot the server.
- C、Apply the latest service packs to the operating system.
- D、Perform a root cause analysis
正确答案:D
第2题：
An administrator has received an update CD with the latest technology level for AIX 5.3. The current operating system level of the server is at base AIX 5.3. What action needs to be taken to apply the new technology level to the server？（）
- A、Run smit update_all
- B、Run smit install_all
- C、Boot from the installation media
- D、Run the update_all command from the mounted CD
正确答案:A
第3题：
A. Battery needs to be replaced
B. Light switch is turned off
C. Smart cable is disconnected
D. UPS needs a firmware update
第4题：
The latest SCSI adaptor card is purchased from a vendor. Drivers for the operating system cannot be obtained. The SCSI adapter card is added to an existing server. Upon booting， the operating system does not detect the card. Which of the following is the MOST likely cause of the problem？（）
- A、 The SCSI card is not seated correctly.
- B、 The termination is incorrectly set on the SCSI card.
- C、 The SCSI card is not listed on the operating system HCL （Hardware Compatibility List）.
- D、 Operating system patches were not updated before installing the card.
正确答案:C
第5题：
An administrator has a malfunctioning uninterruptible power supply (UPS). Which of the following is the MOST likely cause of the problem?（）
- A、Battery needs to be replaced
- B、Light switch is turned off
- C、Smart cable is disconnected
- D、UPS needs a firmware update
正确答案:A
第6题：
A just announced two-port Ethernet card has been installed on a system and it is not recognized. On the HMC the slot shows empty. The device driver has been installed and cfgmgr runs normally. What is the most appropriate action to solve this problem?（）
- A、Update the HMC software
- B、Update the system firmware
- C、Re-install the device driver
- D、Flash update the two-port card
正确答案:B
第7题：
An administrator is troubleshooting a problem on an application server， but has not determined the cause of the problem and is not able to replicate the problem. Which of the following should the administrator do prior to escalating the issue？（）
- A、 Gather information from users.
- B、 Reboot the server.
- C、 Apply the latest service packs to the operating system.
- D、 Perform a root cause analysis.
正确答案:A
第8题：
A.The adapter must be taken offline prior to the firmware update.
B.The system has not been rebooted since the adapter was added to the LPAR.
C.The adapter must be assigned to the service partition prior to updating the firmware.
D.The adapter must be dynamically removed from the LPAR prior to updating thefirmware.
第9题：
A workstation has an error message that states “NTLDR is missing”. Which of the following is MOST likely the cause?（）
- A、The system did not shutdown gracefully
- B、The CMOS battery is dead
- C、The BIOS firmware is corrupt
- D、A virus has corrupted the file
正确答案:D
第10题：
A client has tried to update the firmware of an Ethernet adapter on a p5 590, however it repeatedly fails. What is the most likely cause of this problem?（）
- A、The adapter must be taken offline prior to the firmware update
- B、The adapter must be assigned to the service partition prior to the firmware update
- C、The system has not been rebooted since the adapter was added to the Logical Partition
- D、The adapter must be dynamically removed from the Logical Partition prior to the firmware update
正确答案:A