In which of the following configurations should a SAS hard drive jumper be placed for single drive operation?（）A、The jumpers should be placed in the single/master position.B、There are no configuration jumpers needed on a SAS hard drive.C、The jumpers shoul

第1题：

A technician has lost a necessary jumper for a new hard drive that must be installed immediately.Which of the following is the BEST solution?（）

• A、Use a jumper from the motherboard where the new drive is going to be installed.
• B、Use a jumper from a hard drive that is no longer functioning.
• C、Contact the manufacturer of the new hard drive and have a replacement jumper shipped immediately.
• D、The new hard drive must be replaced

第2题：

A PC is powered on and begins POST. The PC takes a long time when scanning for drives. The BIOS reports no hard drive can be found but the CD-ROM is identified. The technician knows that there are two hard drives on the primary EIDE controller and a CD-ROM on the secondary EIDE controller. Which of the following is the MOST likely cause of the problem?（）

• A、Both hard drives have the master jumper in place.
• B、One hard drive is set as master and the other slave.
• C、The hard drive data cable is reversed.
• D、Both hard drives have the cable select jumper in place.

第3题：

第4题：

In which of the following locations would a technician set the LBA mode for a hard drive？（）

• A、Jumper Settings
• B、Disk Manager
• C、Device Manager
• D、System BIOS

第5题：

An administrator has removed a SATA hard drive from a failed server. Which of the following adapters would MOST likely be used by the administrator to transfer files from the drive to a laptop？（）

• A、SATA to SCSI
• B、SATA to HBA
• C、SATA to USB
• D、SATA to SAS

第6题：

A server has a single failed hard drive in an array that is accessed through a hot plug backplane to ease replacement of failed drives. After replacing the drive several times， each of the replacement drives failed to power up and rebuild as the failed drive.  Which of the following is the MOST likely cause of the failures？（）

• A、 The backplane has failed and needs to be replaced.
• B、 The array must be disbanded and recreated from a backup source to recognize the replacement drive.
• C、 There is a conflict with the optical drive on the server.
• D、 The server power supply is failing and not providing enough power for all the drives.

第7题：

On which of the following hard drive types must Bob, a technician, change the jumper setting to match the motherboard/cabling combination?（）

• A、SATA
• B、eSATA
• C、Solid state
• D、PATA

第8题：

第9题：

Which of the following should be done FIRST to a hard drive before it is disposed?（）

• A、Partition
• B、Physical damage
• C、Data wipe
• D、Format

第10题：

After installing a new SATA hard drive the technician notices the drive is hot to the touch and is giving off a slight odor. Which of the following should the technician do? （）

• A、Install a larger fan near the hard drive to cool the system.
• B、Clean the drive with compressed air and continue to use it.
• C、Remove and replace the drive.
• D、Apply more thermal compound and reseat the drive.