移动综合接入专业考试
ARP（Address Resolution Protocol）用于将一个IP地址映射到正确的MAC地址。ARP可以分为（）两种.A、动态和静态B、逻辑和物理C、二层和三层D、面向连接和面向非连接
题目
ARP（Address Resolution Protocol）用于将一个IP地址映射到正确的MAC地址。ARP可以分为（）两种.
- A、动态和静态
- B、逻辑和物理
- C、二层和三层
- D、面向连接和面向非连接
相似问题和答案
第1题：
Ospf routing protocol typically runs over ( )
A.IP
B.TCP
C.UDP
D.ARP
OSPF协议是运行在IP协议之上。
第2题：
A. RARP request
B. Show Network Address request
C. Proxy ARP request
D. ARP request
E. Show Hardware Address request
第3题：
术语ARP代表什么()。
A.Addresss Resolution Phase
B.ARP Resolution Protocol
C.Address Resolution Protocol
D.Address Recall Protocol
第4题：
Which statement is correct regarding the operation of DHCP?（）
- A、A DHCP client uses a ping to detect address conflicts.(ARP)
- B、A DHCP server uses a gratuitous ARP to detect DHCP clients.
- C、A DHCP client uses a gratuitous ARP to detect a DHCP server.
- D、If an address conflict is detected, the address is removed from the pool and an administrator must resolve the conflict.
- E、If an address conflict is detected, the address removed from the pool for an amount of time configurable by the administrator.
- F、If an address conflict is detected, the address is removed from the pool and will not be reused until server is rebooted.
正确答案:D
第5题：
Select the 3 best answers describing operation and configuration of Frame-Relay Inverse ARP.（）
- A、Dynamic address mapping uses Frame Relay Inverse ARP to request the next-hop protocol address for a specific connection on its known DLCI
- B、Responses to Inverse ARP requests are entered in an address-to-DLCI mapping table on the router or access server which is used to supply the next-hop protoco address or the DLCI for outgoing traffic
- C、Inverse ARP is enabled by default for all protocols enabled on the physical interface
- D、Inverse ARP is configured using the following command under the Interface configuration ’frame-relaymap dlci （dlci number） protocol protocol-address’
- E、Inverse ARP in Frame-Relay is synonymous of ARP in Ethernet
正确答案:A,B,C
第6题：
A. To ma a known IP address to a MAC address
B. To map a known DLCI to a MAC address
C. To ma a known MAC address to an IP address
D. To ma a known DLCI address to a IP address
E. To ma a known IP address to a SPID address
F. To ma a known SPID address to a MAC address
第7题：
A.A DHCP client uses a ping to detect address conflicts.(ARP)
B.A DHCP server uses a gratuitous ARP to detect DHCP clients.
C.A DHCP client uses a gratuitous ARP to detect a DHCP server.
D.If an address conflict is detected, the address is removed from the pool and an administrator must resolve the conflict.
E.If an address conflict is detected, the address removed from the pool for an amount of time configurable by the administrator.
F.If an address conflict is detected, the address is removed from the pool and will not be reused until server is rebooted.
第8题：
What refers to the protocols used to determine who goes next on a multi-access channel?(29)
A．MAC(medium access control)
B．ARP(address resolution protocol)
C．NAT(network address translation)
D．CIDR(classless interdomain routing)
第9题：
以下哪个一个项对“ARP”的解释是正确的？（）
- A、Access routing protocol----访问路由协议
- B、Access routing protocol----访问解析协议
- C、Address resolution protocol-地址解析协议
- D、Address recovery protocol-地址恢复协议
正确答案:C
第10题：
You are troubleshooting a one-way call problem with a cisco 7920 wireless ip phone on a standalone wlan. What may cause this problem？（）
- A、the minimum data rate is not set to 11 mbps.
- B、an address resolution protocol has been disabled
- C、publicly secure packet forwarding is enabled
- D、the access point is set to the least congested channel.
正确答案:B