单选题An administrator is trying to connect to an RSA-II adapter using the default IP address found in the installation manual of 192.168.70.125.  The Web browser returns a "page cannot be displayed" message， and a ping returns a "request timed out" message.

第1题：

After creating a virtual Ethernet adapter in slot #3 of logical partition #5， the user needs to configure the adapter in AIX. Which of the following location codes matches this virtual Ethernet adapter？（）

• A、U9111.520.1000000-V5-C3-T1
• B、U9111.520.1000000-V3-C5-T1
• C、U9111.520.1000000-V5-C1-T3
• D、U9111.520.1000000-V1-C3-T5

第2题：

Multiple users are trying to telnet to the AIX server. They are able to ping the server successfully， but are getting the following error message：  telnet： connect： A remote host refused an attempted connect operation   Which of the following could be the cause of this problem？（）

• A、The routing table on the AIX server is incorrect.
• B、The IP address on the network adapter is incorrect.
• C、The portmap daemon is not running on the AIX server.
• D、The inetd daemon is not running on the AIX server.

第3题：

第4题：

An administrator is up grading the back up server from a single tape drive to a SCSI tape library. The library has been unpackaged， mounted， and the library drivers installed.  Which of the following items should the administrator have to connect the device to the backup server？（）

• A、 SCSI cable
• B、 SCSI interface adapter on the tape library
• C、 SCSI termination card on the server
• D、 iSCSI cable

第5题：

An administrator attempts to install the latest security patches for an older server. When the administrator runs the patch installer， the install fails. The administrator tries again， and the installer fails again.  Which of the following is the MOST likely reason for this？（）

• A、 The administrator improperly configured the virtual memory settings on the server.
• B、 The administrator is using incorrect patch switches for the install.
• C、 The administrator is trying to install security patches for software that is not installed.
• D、 The administrator is trying to install patches that require hard drive encryption on the server.

第6题：

Your computer has a wireless network adapter installed. However， the computer fails to connect to the wireless network.  You need to ensure that the computer is able to connect to the wireless network.  What should you do？（）

• A、Change the Network Category setting of the wireless connection to Public.
• B、Enable the Internet Connection Sharing feature on the wireless network adapter.
• C、Rename the wireless network adapter to match the Service Set Identifier （SSID） of the wireless network.
• D、Configure the wireless network adapter to connect to the appropriate wireless network from the Connect to a network list.

第7题：

A network administrator needs to add an additional connection to a room. The administrator adds a new Ethernet switch and must connect it to an existing switch. Which cable type should be used to connect the two switches?（）

• A、CAT3 cable
• B、Serial cable
• C、Crossover cable
• D、Rollover cable

第8题：

第9题：

An administrator needs to connect servers to the Fiber Channel SAN. Which of the following should the administrator install in the servers to allow this connection？（）

• A、Riser
• B、HBA
• C、SCSI card
• D、SAS card

第10题：

Companycom recently ordered a p5 570 and an HMC. Prior to delivery, two additional p5 570 servers were added to the order. Upon installation, the system administrator noticed that they do not have a method to connect the p5 570 servers to the HMC. Which of the following will allow them to connect all servers to the HMC?（）

• A、An 8-port adapter to the HMC
• B、A hub for the private network
• C、An additional Ethernet card to the HMC
• D、An additional Ethernet card for each partition