NT2
NT1
TE
TA
TE1
第1题:
Refer to the exhibit. ROUTE Enterprises has many stub networks in their enterprise network, such as router B and its associated network. EIGRP is to be implemented on router A so that neither the prefix for the S/0/0/0 interface nor the prefixes from router B appear in the routing tables for the router in the enterprise network. Which action will accomplish this goal?()
A. Declare router B a stub router using the eigrp stub command.
B. Use the passive - interface command for interface Serial0/0/0.
C. Use a mask with the network command to exclude interface Serial0/0/0.
D. Implement a distribute list to exclude the link prefix from the routi ng updates.
第2题:
A. show interfaces serial 0/0
B. show running-config
C. show version
D. show controllers serial 0/0
E. show ip interface
F. show line serial 0/0
第3题:
A. SSH
B. Telnet
C. WebView
D. device front panel
E. serial console (command-line interface)
第4题:
A. Router John uses a link-state routing protocol.
B. Router John will receive routing updates on the Serial0/0 interface.
C. Router John will receive routing updates on the Serial0/1 interface.
D. Router John will send routing updates out the Serial0/0 interface.
E. Router John will send routing updates out the FastEthernet0/0 interface.
F. Router John will send routing updates out the Serial0/1 interface.
第5题:
A. Nothing. The router is already suitable.
B. A BRI WAN interface in the router.
C. An external NT1 to terminate the local loop.
D. A TA/NT1 device on the router.
第6题:
A.NT2
B.NT1
C.TE
D.TA
E.TE1
第7题:
TestKing.com is configuring the serial interface of a Cisco router to connect to the router of a new ISP. A full T1 is being used for the Internet connection. After issuing the show interface serial 0/0 command, it is observed that the interface is UP and the line protocol is DOWN.Which of the following commands could fix this problem?()
A. Border# copy running-config startup-config
B. Border(config)# no shutdown
C. Border(config-if)# encapsulation ppp
D. Border(config-if)# no cdp enable
E. Border(config-if)# ip routing
第8题:
A. Network Interface Card
B. Hub
C. Bridge
D. Router
第9题:
A.Router John uses alink-state routing protocol.
B.Router John will receive routing updates on the Serial0/0 interface.
C.Router John will receive routing updates on the Serial0/1 interface.
D.Router John will send routing updates out the Serial0/0 interface.
E.Router John will send routing updates out the FastEthernet0/0 interface.
F.Router John will send routing updates out the Serial0/1 interface.
第10题:
Which command can be used to determine the type of cable attached to the Serial 0/0 interface on a router?()