It is useful for diagnosing data dependent problems by filling the packet with the byte pattern following the f in the command line.
It is useful for flooding from slow character based terminals since it only displays a dot . for each packet sent in fast mode.
It is useful for flooding from slow character based terminals since it only displays a dot . for each packet sent and a backspace on returned in fast mode.
The command can only be run by root.
第1题:
A. The job is enabled by default after creation
B. The job is automatically dropped after the end date
C. The job executes with the privileges of the user SYS
D. The globalization environment that exists at the time of the job creation prevails at the job runs
第2题:
A.TRACERT
B.IPCONFIG/ALL
C.NSLOOKUP
D.PING-T
第3题:
Regarding the extended ping command; which of the statements below are true?
(Select all valid answer choices)
A.The extended ping command is supported from user EXEC mode.
B.The extended ping command is available from privileged EXEC mode.
C.With the extended ping command you can specify the TCP and UDP port to be pinged.
D.With the extended ping command you can specify the timeout value.
E.With the extended ping command you can specify the datagram size.
第4题:
The following configuration command was issued on router TK1:ip route 172.16.3.0 255.255.255.0 192.168.2.1.Which of the following statements are true regarding this command?()
第5题:
A.There are at least two routers participating in the RIP process.
B.A ping to 192.168.168.2 will be successful.
C.A ping to 10.0.15.2 will be successful.
D.RtrA has three interfaces participating in the RIP process.
第6题:
A. The submit command exits the GUI.
B. The submit command reboots the WX device.
C. The submit command saves and writes the configuration to flash.
D. The submit command is the same as the commit CLI command.
第7题:
A. The default administrative distance is used.
B. The command is used to establish a static route.
C. The command is used to configure the router interfaces.
D. The command is used to establish a stub network.
E. The subnet mask for the source address is 255.255.255.0
第8题:
A. The job is enabled by default after creation
B. The job is automatically dropped after the end date
C. The job executes with the privileges of the user SYS
D.
第9题:
第10题:
Which of the following commands would result in the following output: M.M.M()。