CMS专题
单选题What interface is created when an FC Port Channel is created on a Cisco Unified Computing System？（）AAn interface ’san-port-channel’ in NXOSBAn interface ’port-channel’ in NXOSCAn interface ’port-channel’ with ’mode fc’ configuredDAn interface ’fc-port-
题目
An interface ’san-port-channel’ in NXOS
An interface ’port-channel’ in NXOS
An interface ’port-channel’ with ’mode fc’ configured
An interface ’fc-port-channel’ in NXOS
相似问题和答案
第1题：
A.Aninterface’san-port-channel’inNXOS
B.Aninterface’port-channel’inNXOS
C.Aninterface’port-channel’with’modefc’configured
D.Aninterface’fc-port-channel’inNXOS
第2题：
Which two statements about SAN port channels configured on Cisco Nexus 5000 Series switches are true？ （）
- A、 The bring up protocol automatically detects and overrides any misconfiguration.
- B、 You can manually configure channel groups， or they can be automatically created.
- C、 Changes in configuration to the SAN port channel interface must also be made to all members of the channel group.
- D、 The port channel protocol uses the exchange fabric parameters command to communicate across peer ports in an ISL.
- E、 The port channel protocol ensures that a set of ports is eligible to be part of the same SAN port channel.
正确答案:B,E
第3题：
In your database, the flash recovery area (FRA) is configured as the default for RMAN backups. You executed the following commands to configure the settings in RMAN:Which statement is true about the outcome?（）
A. Only one channel is allocated and the backup is created in the flash recovery area
B. Only one channel is allocated and the backup is created in the destination specified for channel
C. Two channels are allocated and backup sets are created in the destinations specified for channels 1 and 2
D. Three channels are allocated and backup sets are created in the destinations specified for channels 1, 2, and FRA
第4题：
An SVI has been configured on a device. Which two statements are true about a switched virtual interface （SVI）？（）
- A、An SVI is normally created for the default VLAN （VLAN1） to permit remote switch administration.
- B、Multiple SVIs can be associated with a VLAN.
- C、SVI is another name for a routed port.
- D、An SVI is created by entering the no switchport command in interface configuration mode.
- E、An SVI provides a default gateway for a VLAN.
正确答案:A,E
第5题：
When troubleshooting a network， the output of the command show interfaces indicates a large number of runts. What is a runt？（）
- A、the number of packets that are discarded because they exceed the maximum packet size of the medium
- B、errors created when the CRC generated by the originating LAN station or far-end device does not match the checksum calculated from the data received.
- C、the number of packets that are discarded because they are smaller than the minimum packet size of the medium
- D、the number of received packets that were ignored by the interface because the interface hardware ran low on internal buffers
- E、the number of times that the interface requested another interface within the router to slow down
正确答案:C
第6题：
What interface is created when an FC Port Channel is created on a Cisco Unified Computing System？（）
- A、 An interface ’san-port-channel’ in NXOS
- B、 An interface ’port-channel’ in NXOS
- C、 An interface ’port-channel’ with ’mode fc’ configured
- D、 An interface ’fc-port-channel’ in NXOS
正确答案:A
第7题：
What does the number one 1 represent for interface fe-0/0/1？（）
- A、port number
- B、PCI slot number
- C、channel number
- D、virtual PIC number
正确答案:A
第8题：
A.the port-channel 1 interface
B.the highest number member interface
C.all member interfaces
D.the lowest number member interface
第9题：
Given the following output： san-port-channel 12 is up Hardware is Fibre Channel Port WWN is 24：0c：00：0d：ec：d3：5c：00 Admin port mode is NP， trunk mode is on Port mode is NP Port vsan is 1 Speed is 8 Gbps Member[1] ： fc2/3 Member[2] ： fc2/4 What does "Speed is 8 Gbps" indicate？（）
- A、 The speed of the slowest interface in the port channel
- B、 The combined speed of all interfaces configured in the port channel
- C、 The combined speed of all interfaces in the port channel that are up
- D、 The speed that can be achieved if all buffers are used
正确答案:C
第10题：
A Cisco switch has this configuration for a port channel connecting to an ESXi using dual NICs and is intended for use with an N1Kv. Interface fastethernet 1/10 Switchport mode trunk Switchport trunk allowed vlan all Channel-group 10 mode on No shut Interface fastethernet 1/11 Switchport mode trunk Switchport trunk allowed vlan all Channel-group 10 mode on No shut Interface port-channel 10 Switchport mode trunk Switchport allowed vlan all No shut Which Port Channel configuration must be used on the Nexus 1000v port-profile？（）
- A、 MAC pinning
- B、 Cisco Discovery Protocol pinning
- C、 Mode On
- D、 Mode Active
- E、 No port channel configuration
正确答案:C