OSPF works on F0/0 and S0/0/0 without further configuration
OSPF works with the addition of one command: a no shutdown command in OSPF router configur ation modE
OSPF works with the addition of one command: an router - id command in OSPF router configuration modE
OSPFv3 needs at least two more configuration commands before it works on R1
第1题:
Refer to the exhibit. OSPF has been configured on all routers in the network. However, router R1 does not receive a default route to router R2 as in tended. Which configuration change would ensure that R1 would receive a default route from R2? ()
A. Add the area 1 stub command on routers R1.
B. Add the always keyword to the default - information originate configuration command on router R2.
C. Remov e the default information originate configuration command from router R2 and place it on router R1.
D. Add the ip route 5.0.0.0 255.255.255.0 0.0.0.0 command to router R2.
第2题:
Router R1 uses S0/0 to connect via a T/1 to the Frame Relay servicE. Five PVCs terminate on the serial link. Three PVCs (101, 102, and 103) are configured on subinterface S0/0.1, and one each (104 and 105) are on S0/0 .2 and S0/0.3. The configuration shows no configuration related to EIGRP WAN bandwidth control, and the bandwidth command is not configured at all. Which of the following is true about how IOS tries to limit EIGRP's use of bandwidth on S0/0?()
第3题:
A.A
B.B
C.C
D.D
第4题:
On router R1, which three of the following protocols will be forwarded to a host specified by the "iphelper-address" interface configuration command if the configuration has not been modified by the"ip forward-protocol udp" global configuration command?()
第5题:
In which Cisco IOS configuration mode is the route distinguisher (RD) configured?()
第6题:
A. Router R2 will be preferred because it has the higher neighbor IP address.
B. Router R2 will be preferr ed because its neighbor has a lower autonomous system number.
C. Router R1 will be preferred because it has a lower local preference.
D. Router R2 will be preferred because it has a higher local preference.
E. Router R1 will be preferred because its nei ghbor has the higher autonomous system number.
F. Router R1 will be preferred because it has the lower neighbor IP address.
第7题:
You administer a network that uses two routers, R1 and R2, configured as an HSRP group to provide redundancy for the gateway. Router R1 is the active router and has been configured as follows: R1#configure terminal R1(config)#interface fa0/0 R1(config-if)#ip address 10.10.0.5 255.255.255.0 R1(config-if)#standby 1 priority 150 R1(config-if)#standby preempt delay minimum 50 R1(config-if)#standby 1 track interface fa0/2 15 R1(config-if)#standby 1 ip 10.10.0.20 Which of the following describes the effect the standby preempt delay minimum 50 command will have on router R1?()
第8题:
A. Metric
B. Administrative distance
C. Timeout (seconds)
D. Prefix length
E. Interface ID
第9题:
An engineer has added the following configuration snippet to an implementation planning document. The configuration will be added to Router R1, whose Fa0/0 interface connects to a LAN to which Routers R2 and R3 also connect. R2 and R3 are already EIGRP neighbors with each of her. Assuming the snippet shows all commands on R1 related to EIGRP authentication, which answer lists an appropriate comment to be made during the implementation plan peer review?() key chain fred key 3 key - string whehew interface fa0/0 ip authenticat ion key - chain eigrp 9 fred
第10题:
Router R1, an ASBR connected to the Internet and to backbone area 0, has been configured with a default - information originate command. Which of the following is true about the effects of this configuration command?()