Specific addresses can be selected using a prefix list.
Specific addresses can be selected using a route map.
Specific addresses cann ot be selected for importation into the OSPF process.
Specific addresses can be selected using an ACL.
第1题:
A. show ip ospf database
B. show ip ospf interface brief
C. show ip protocols
D. show ip route ospf
E. show ip ospf neighbors
第2题:
A. Hierarchical OSPF networks need to be in one area
B. Multiple OSPF areas must connect to area 0
C. Single area OSPF networks must be configured in area 1
D. Areas can be assigned any number from 0 to 63535
E. Area 0 is called the backbone area
F. Each OSPF area need to be configured with a loopback interface
第3题:
A.1
B.100
C.2048
D.4096
第4题:
A.network 0.0.0.0 255.255.255.255 area 0
B.network 0.0.0.0 0.0.0.0 area 0
C.network 255.255.255.255 0.0.0.0 area 0
D.network all-interfaces area 0
第5题:
A. Ensure that an interface has been configured with an IP address
B. Ensure that IP classless is enabled
C. Ensure that the interfaces can ping their directly connected neighbors
D. Ensure that an interface has been configured with an IP address and is up
第6题:
Refer to the exhibit. Router C was configured so that it could form an adja cency with three OSPF neighbors, one connected to each of its three physical interfaces. Which statement is correct about router C?()
A. It is configured and functioning correctly as an OSPF internal router.
B. It is configured and functioning correc tly as an ABR attached to stub area 4.
C. It is configured and functioning correctly as an ASBR attached to external area 4.
D. It is configured and functioning correctly as an ABR attached to totally stubby area 4.
E. It is not configured correctly to function as specified.
第7题:
A. router ospf ipv6 process - id
B. ipv6 ospf process - id
C. router ospf process - id
D. ipv6 router ospf process - id
第8题:
A.Units in JUNOS are always required for any interface configured with logical addresses such as IP and IPv6.
B.Units in JUNOS are only required when you are configuring sub-interfaces for inter-VLAN routing.
C.Unit numbers must match the DLCI or VCI numbers configured on the interface.
D.Unit 0 is the only value allowed on interfaces running HDLC, PPP, or for Ethernet interfaces not doing VLAN-tagging.
第9题:
A. The IP address of the first Fast Ethernet interface.
B. The IP address of the console management interface.
C. The highest IP address among its active interfaces.
D. The lowest IP address among its active interfaces.
E. There will be no router ID until a loopback interface is configured.
第10题:
Which statement is true about IPv6?()