The Boot IOS Code is Located in the NVRAM.
Check NVRAM for boot system Commands.
Bypass NVRAM Configurations.
Boot the IOS Code Located in ROM.
Perform a Password Recovery.
Bypass The Code In ROM.
第1题:
After making changes to the router, you issue the "copy running-config startup-config" command to save changes. After reloading the router, the router comes up in setup mode. You again make changes, save them, and reboot. Again,the router comes up in setup mode.What is the most likely cause of this?()
A. The NVRAM is corrupted.
B. The boot system commands were omitted in the configuration.
C. The configuration register setting is incorrect.
D. The upgraded configuration incompatible with the hardware platform.
E. The upgraded IOS incompatible with the hardware.
第2题:
A. The IOS image will be ignored.
B. The router will prompt to enter initial configuration mode.
C. The router will boot to ROM.
D. Any configuration entries in NVRAM will be ignored.
E. The configuration in flash memory will be booted.
第3题:
What will cause a Ezonexam router to enter setup mode? (Choose two)
A. The configuration file is missing in NVRAM.
B. The configuration register is set to 0x2100.
C. Boot system commands are misconfigured in the running-configuration.
D. The setup command was issued from the privileged mode prompt.
E. The IOS is missing.
F. The IOS is corrupt.
第4题:
A network administrator changes the configuration register to 0x2142 and reboots the router. What are two results of making this change?()
第5题:
FCAPS is a network maintenance model defined by ISO. What does it stand for?()
第6题:
A. Erase flash.
B. Restart the switch.
C. Delete the VLAN database.
D. Erase the running configuration.
E. Erase the startup configuration.
F. Modify the configuration register.
第7题:
第8题:
What is the default configuration register setting on most Cisco routers?
A. 0x2104
B. 0x2012
C. 0x2210
D. 0x2102
E. 0x2142
F. None of the above
第9题:
What does a configuration Register Setting of 0x2105 indicate to the Router? ()
第10题:
A Cisco router is booting and has just completed the POST process. It is now ready to find and load an IOS image. What function does the router perform next?()