单选题Which Cisco access point should be used for a customer site that requests hardware to supportMaximal Ratio Combining indoors？（）A AP1130B AP1242C AP1252D BR1310

第1题：

Which Cisco access point should be used for a customer site that requests hardware to supportMaximal Ratio Combining indoors？（）

• A、AP1130
• B、AP1242
• C、AP1252
• D、BR1310

第2题：

Which three devices are used by the Cisco Wireless Control System （WCS） for wireless management？（）

• A、WLAN controllers
• B、WLAN Solution Engine （WLSE）
• C、Cisco Wireless Control System （WCS）
• D、Cisco Wireless Location Appliance
• E、lightweight access point （AP）
• F、autonomous access point （AP）

第3题：

Where should known problem areas in the site survey be documented？（）

• A、nowhere （but should be discussed with the customer）
• B、on the site survey map and within the site survey text
• C、on the customers blueprints
• D、in the Cisco WCS Planning Tool

第4题：

The Cisco 521 Wireless Express Access Point used in the Smart Business Communications System can be configured to operate in which mode?（）

• A、controller-based mode only
• B、either standalone mode or controller-based mode
• C、standalone mode only

第5题：

Which two of these statements describe important aspects of performing a wireless site survey？ （Choose two.）  （）

• A、 An 802.11 g access point with a variety of antennas can be used in all standard site surveys.
• B、 Site surveys can be performed manually or through assisted site survey.
• C、 Channel power during testing starts at the default minimum and gradually increases to the maximum.
• D、 Overlapping access points can create performance problems.
• E、 Surveys should be done after hours in an office building or during reduced inventory levels in warehouses.

第6题：

A rogue access point is detected on the Cisco WCS console. Upon investigation， the access point isdiscovered to belong to a neighboring business. Your administrator should designate the rogueaccess point as which of the following？（）

• A、known internal
• B、managed
• C、friendly
• D、known external

第7题：

If an enterprise customer required A switch for their branch office access layer, which family of switches would the customer likely choose from?（）

• A、Cisco SFS 3000/7000
• B、Cisco Catalyst 2000 and 3000
• C、Cisco Catalyst 4000 and 6000
• D、Cisco Nexus

第8题：

The AirMagnet passive site survey tool can provide RF coverage data， except for which parameter？（）

• A、Signal strength （4th access point）
• B、Signal strength （3rd access point）
• C、Channel interference
• D、Predictive physical data rate downlink （2nd access point）

第9题：

Which of these is a phase of Cisco Lifecycle Service？（）

• A、site readiness assessment
• B、business requirements development
• C、design
• D、site survey
• E、customer education

第10题：

You are the network consultant from Cisco.com.Your customer has eight sites and will add in thefuture. Branch site to branch site traffic is approaching 30 percent. The customer’s goals are to make iteasier to add branch sites in the future and to reduce traffic through the hub. Which VPN topology should you recommend？（）

• A、 Easy VPN
• B、 IPsec GRE tunneling
• C、 Virtual Tunnel Interfaces
• D、 Dynamic Multipoint VPN