The memory is not the correct CAS latency.
The memory is not installed in the correct slot.
The memory does not have the correct timing.
The memory is not the correct speed.
第1题:
On a Hardware Management Console (HMC) at version 7, an administrator has an LPAR defined with a minimum of 4GB of memory, 6GB desired and a maximum of 16 GB of memory. The administrator wants to go from 5 GB to 8 GB assigned memory for this partition. In order to make the change, what value should the administrator enter into the add processor resources window? ()
第2题:
Which command helps a network administrator to manage memory by displaying flash memory andNVRAM utilization?()
第3题:
An administrator is experiencing availability issues on a Linux server. The administrator decides tocheck the server for an IP address conflict on the server. Which of the following commands should the administrator use?()
A.traceroute
B.tracert
C.ifconfig
D.ipconfig
第4题:
A technician is installing new memory in a server. The technician would consult the HCL to ensure which of the following?()
第5题:
The operating system partition on a server is nearly out of space on a Windows 2003 Server. The administrator notices that the file pagefile.sys is taking up nearly 2GB of space. Which of the following would BEST resolve this problem?()
第6题:
An administrator has implemented the following LPARs on a Power 570 with 32 GB memory with 512 MB remaining for allocation: LPAR 1 memory : min = 10 GB des = 15 GB max = 24 GB LPAR 2memory : min = 10 GB des = 15 GB max = 24 GB The administrator receives a request to add 2 GB to LPAR 1. The only way to do this is by moving memory from LPAR 2 to LPAR 1. The administrator attempts to move the memory, but the operation fails. The administrator can however allocate 512 MB that is free to LPAR 1 on the 570. What is the most likely cause of this failure when dynamically moving memory?()
第7题:
An administrator is adding additional memory into a server that registers 1GB of memory in the OS and notices that the system has 2GB of memory physically installed; however, the server only shows 1GB of memory during POST. Which of the following is the MOST likely reason for this?()
第8题:
Memory was recently taken out of a fully functional production server before it wasdecommissioned and added to another server. Upon booting up the server with the additional memory the server emits a series of beeps and fails to POST. Which of the following is MOST likely the problem?()
第9题:
An administrator attempts to install the latest security patches for an older server. When the administrator runs the patch installer, the install fails. The administrator tries again, and the installer fails again. Which of the following is the MOST likely reason for this?()
第10题:
An administrator is upgrading memory on the server. Once the server in turned back on, the administrator notices that the memory has not changed. The system board website says the board should accept the new amount of memory. Which of the following should the administrator do FIRST?()