sensor failure
failed alarm
low level
extremely high level
第1题:
A. Compression can be enabled at the table, tablespace, or partition level for direct loads only.
B. Compression can be enabled only at the table level for both direct loads and conventional DML.
C. Compression can be enabled at the table, tablespace, or partition level for conventional DML only.
D. Compression can be enabled at the table, tablespace, or partition level for both direct loads and conventional DML.
第2题:
A.Low pressure of the lubricating oil
B.Low level of the lubricating oil
C.High temperature of the lubricating oil
D.High temperature of the cooling water
第3题:
此题为判断题(对,错)。
第4题:
Clearances of bridges and overhead cables below Bonneville Dam refer to heights in feet above mean ______.
A.lower low water
B.high water
C.low water
D.sea level
第5题:
A. The FCIP stack supports file-level storage for remote devices.
B. Both require high throughput with low latency and low jitter.
C. The purpose of FCIP is to provide connectivity between host and storage.
D. TheiSCSI stack supports block-level storage for remote devices.
E. The purpose ofiSCSI is to provide connectivity between separate wide-area SANs.
第6题:
A.Low level is monitored on the drain tank and header tank.
B.If there is high differential the filters pressure across the circulating
pumps is alarmed
C.The lubricating oil purifier cannot take oil from the drain tank
D.If the sea water pressure falls, this also operates an alarm
第7题:
Overheating of the hydraulic fluid in an electro-hydraulic anchor windlass can result from a/an( ).
A.overload on the pump motor
B.low fluid level in the reservoir
C.low fluid viscosity around the shaft seal
D.high oil level in the sump
第8题:
A、HIGH、LOW、MIDDLE
B、LOW、MIDDLE、HIGH
C、MIDDLE、LOW、HIGH
D、HIGH、MIDDLE、LOW
第9题:
If both the ‘high level’and ‘low level’ alarms come on for the same address of a centralized(集中的) control console, the most likely problem is a/an ______.
A.sensor failure
B.failed alarm
C.low level
D.extremely high level
第10题:
The height of a light is measured from which reference plane?
A.Mean low water
B.Mean high water
C.Average water level
D.Geographical sea level