单选题During a fire drill on a vessel,what action is required?（）.A Start each fire pumpB Launch aand run a lifeboatC Inventory rescue and fire equipmentD Inspect fire hoses

A vessel is entering port A for the first time and has a Pilot conning the vessel. The Master is unsure that the Pilot is taking sufficient action to prevent a collision. What should the Master do? ______.

A.Nothing； The Pilot is required by law and is solely responsible for the safety of the vessel

B.State his concerns to the Pilot but do not interfere with the handling of the vessel

C.Direct the Pilot to stop the vessel and anchor if necessary until the situation clears

D.Recommend an alternative action and if not followed relieve the Pilot

When loading bulk liquid cargo，what is the first action you should take if a cargo valve jammed open?

A.Call the owner，operator，or terminal supervisor

B.Unplug the deck scuppers

C.Order the dock man to shut down

D.Run out the vessel's or terminal's fire hose

during bunkering in the last vessel ,what were you assigned to do ?or what was your position during bunkering on your last vessel ?

If you saw flames aboard a vessel but could see the vessel was not on fire, you would known that the ______.

A.crew was trying to get warm

B.vessel required immediate assistance

C.vessel was attempting to attract the attention of a pilot boat

D.vessel was being illuminated for identification by aircraft

At the required fire drill conducted aboard a vessel, all persons must report to their stations and demonstrate their ability to perform the duties assigned to them ______.

A.by the tool pusher

B.in the station bill

C.by the person conducting the drill

D.at the previous safety meeting

______ of the following statements is INCORRECT regarding a fire and boat drill on board your cargo vessel.

A.At least one fire and boat drill shall be held within 24 hours of leaving a port where more than 25 percent of the crew has been replaced

B.The Master is responsible in seeing that each lifeboat is lowered to the water at least once in each 6 months．

C.Lifeboat equipment shall be examined at least once each month to insure that it is complete

D.An entry shall be made in the vessel's Official Logbook relative to each fire and boat drill

What is(are) standard operating procedure(s) used on a Ro-Ro vessel?

A.Periodic inspection and retensioning of lashings as required during voyage

B.Lashings may be completed after the vessel leaves port

C.One QMED assigned to oversee the initial loading and lashing

D.All of the above

what is your position (station ) in the muster lists ,for example ,during the fire fighting ,abandon vessel ,oil pollution prevention etc ?

During a fire drill on a vessel, what action is required? ______.

A.Start each fire pump.

B.Launch and run a lifeboat.

C.Inventory rescue and fire equipment.

D.Inspect fire hoses