casting interlocking components
welding plates to form sections for assembly
forging integral components
case hardening integral components
第1题:
Vessels required to be equipped with an approved backfire flame arrester are ______.
A.Those with diesel engines
B.All those with gasoline engines
C.Those with large engines only
D.None of the above
第2题:
reduce lube oil temperature
raise exhaust temperature reduce
excessive heating of engine room
reduce load on cooling water pump
第3题:
Cylinders of marine diesel engines are normally cooled by ___ .
A.sea water
B.fine mineral oil
C.sanitary water
D.fresh water
第4题:
cylinder liners and piston rings
main bearings
crankpin bearings
turboblower
第5题:
inefficiency
oiliness
detergency
purity
第6题:
the extra weight required for the diesel reduction gearing
a minimum speed for the engines that limits the minimum speed of the vessel
the higher fuel consumption per SHP
the low efficiency of the system when a controllable pitch propeller is used
第7题:
a single, long-stroke, slow-speed, turbocharged, two-stroke diesel engine
a single, long-stroke, medium-speed, turbocharged, four-stroke diesel engine
two medium-speed, turbocharged, four-stroke diesel engines
a variable-speed AC generator
第8题:
Modern marine diesel engines equipped with mechanical fuel injection operate on a combustion phase within the cycle which is ______.
A.entirely constant pressure
B.entirely constant temperature
C.a combination of constant volume and constant pressure
D.a combination of constant temperature and constant pressure
第9题:
fuel oil vapor at the sludge tank vent
unburned fuel vapors in the scavenge air receiver
lube oil vapors in the crank case
lube oil vapors in the engine room
第10题:
stiffen the bedplate in way of the main bearings to increase the engines longitudinal strength
accept most of the tensile loading that results from the firing forces developed during operation
mount the engine frame securely to the hull to prevent shaft coupling misalignment
connect the crosshead solidly to the piston rod