density
bore
weight
material
第1题:
What should be prepared before disassembly of cylinder for main engine or auxiliary engine?
第2题:
A. RAID 0
B. RAID 1
C. RAID 5
D. RAID 10
第3题:
Each cylinder is closed at the top by a _____, made of a special heat-resistant steel.
A.cylinder liner
B.coupling flange
C.cylinder cover
D.piston crown
第4题:
Which important factor is taken into account when determining an estimate for the maximum network bandwidth to be used by a customer?()
第5题:
Which factor must be considered when determining the order of loading of dissimilar products through the same piping system aboard a tanker?
A.Contamination of the cargo
B.Flash points
C.Reid vapor pressures
D.Specific gravities
第6题:
第一组: The Wartsila 50DF operates on the lean-bum principle: the mixture of air and gas in the cylinder has more air than is needed for complete combustion. Lean combustion reduces peak temperatures and therefore NOx emissions. Efficiency is increased and higher output is reached while avoiding knocking. Combustion of the lean air-fuel mixture is initiated by injecting a small amount of LFO (pilot fuel) into the cylinder. The pilot fuel is ignited in a conventional diesel process, providing a high-energy ignition source for the main engine. To obtain the best efficiency and lowest emissions, every cylinder is individually controlled to ensure operation at the correct air-fuel ratio and with the correct amount and timing of pilot fuel rejection. Wartsila has developed a special electronic control system to cope with the demanding task of controlling the combustion in each cylinder, and to ensure optimal performance in terms of efficiency and emissions under all conditions by keeping each cylinder within the operating window. Stable and well-controlled combustion also contributes to less mechanical and thermal load on the engine components. Current stringent emission regulations demand the reduction of NOx emissions. In an internal combustion engine this means controlling peak temperature and residence time, which are the main parameters governing NOx formations. In the Wartsila 50DF engine, the air-fuel ratio is very high (typically 2.2). Since the same specific heat quantity released by combustion is used to heat up a larger mass of air, the maximum temperature and consequently NOx formation are lower. The mixture is uniform. throughout the cylinder since the fuel and air are premixed before introduction into the cylinders, which helps to avoid local NOx formation points within the cylinder. Benefiting from this unique feature, NOx emissions from the Wartsila 50DF are extremely and comply with the most stringent existing legislation.
What is the combustion feature of the Wartsila 50DF?
A.Lean air in the cylinder
B.Excessive fuel in the cylinder
C.Excessive air in the cylinder
D.Spark ignition
第7题:
The main factor which determines the output of each cylinder is _____.
A.the cylinder weight
B.the cylinder bore
C.the cylinder length
D.the cylinder cover
第8题:
Each cylinder liner on the marine medium speed engines _____.
A.is usually cooled by sea water
B.can be replaced when worn out
C.is in direct contact with the water in the bore of the cylinder
D.can t expand when heated
第9题:
Which of the following RAID levels would be the BEST choice if performance was the only determining factor?()
第10题:
the same, whether at sea, or during maneuvering
adjusted during each hour of operation while at constant RPM
higher at sea than while maneuvering
lower at sea than while maneuvering