Contain the oil and remove as much of it as possible from the water
Throw chemical agents on the water to disperse the oil
Throw sand on the water to sink the oil
Obtain your permit from the Corps of Engineers
第1题:
What is the most usual reason for the fresh water-sea water heat exchanger fouling in the sea side?
A.lube oil sludge accumulating in it
B.dirt and scale etc , formed on the surfaces
C.deformation of the tubes and the shell or the plates
D.lube oil leakage into sea-water side
第2题:
When oil is discharged overboard,an entry is required in the ______.
A.engine rough log
B.Oil Record Book
C.Official Logbook
D.deck rough log
第3题:
What attention should be paid when bunkering oil in the USA?
第4题:
reducing the erosion of the cargo tanks
increasing the total quantity of oil to carry
reducing the quantity of water contained in oil
reducing cargo discharged time
第5题:
第6题:
what chemicals did you use to treat the boiler water ?when you test alkalinity and acidity of water in boiler by pH test paper ? the result shows the boiler water is in acidiity . please describe what the possible cause is .
第7题:
An oil tanker operating with dedicated clean ballast tanks shall be equipped with ______,approved by the Administration on the basis of specification recommended by the Organization,to enable supervision of the oil content in ballast water being discharged.
A.An oil content meter
B.An oil checker
C.An analyzer of oil content
D.A mixer of oily water
第8题:
Have you ever served the auxiliary engine to combustion heavy oil? What should be borne in mind when transferring oil; from heavy oil to light oil?
第9题:
all ballast is processed through the oily water separator
ballast is taken on and discharged through a separate main deck riser
ballast and cargo tanks are separated by cofferdams
all ballast lines, tanks, and pumps are independent of those used for oil
第10题:
mineral oil
machinery oil being transferred for shipboard use
crude oil unrefined
normal bilge oil and water