They establish routes that will never go down.
The keep routing tables small.
They require a great deal of CPU power.
The allow connectivity to remote networks that are not in the routing table.
They direct traffic from the Internet into corporate networks.
第1题:
A.identified
B.isolated
C.initiated
D.immigrated
第2题:
A、for
B、at
C、on
D、in
第3题:
A.been changed
B.changed
C.been changing
第4题:
Refer to the exhibit. All routers have Protocol Independent Multicast (PIM) enabled interfaces. On the basis of the configuration provided on routers R1 and R2, which router will take on the func tion of rendezvous point (RP) for the multicast network? ()
A. both routers R1 and R2
B. router R1
C. router R2
D. none of the routers since they are not configured with static RP
第5题:
A. They establish routes that will never go down.
B. The keep routing tables small.
C. They require a great deal of CPU power.
D. The allow connectivity to remote networks that are not in the routing table.
E. They direct traffic from the Internet into corporate networks.
第6题:
A.I am sorry.The parts have been ordered, but they haven't come in yet.
B.It was supposed to have been ready last week.
C.I will call you as soon as the repair is finished.
第7题:
Refer to the exhibit. Routers R1 and R2 have been configured to operate with OSPF. Routers R1 and R3 have been configured to operate with RIP. After configuring the redistribution between OSPF a nd RIP on R1, no OSPF routes are distributed into RIP. What should be done to correct this problem? ()
A. The redistribution command should be reentered with the match route - type parameter included.
B. The redistribution command should be reentered wit h the route - map map - tag parameter included.
C. The redistribution command should be reentered with the metric metric - value parameter included.
D. Routes will first need to be distributed into another protocol, and then into RIP.
第8题:
A dealing with ;
B to deal with ;
C dealt with
第9题:
A.90
B.100
C.110
D.120
E.130
F.170
G.200
第10题:
There is a connectivity problem between the serial 0/0 interface of router TESTKING1 and the serial 0/0 interface of TESTKING2. A leased line point to point circuit is installed between these two routers. The output from the "show interface serial 0/0" command is displayed below for each of these routers:From your observations of the above exhibit, what is the underlying cause of the problem?()
A. The loopback is not set.
B. The serial cable is faulty.
C. The subnet mask is not configured properly.
D. The IP address is not configured properly.
E. The Layer 2 frame types are not compatible.
F. The keepalive setting is not configured properly.