Use rack specific cabling hardware
Let cables hang loosely behind the servers
Channel all power cables down the sides, and all network cables down the center
Keep cables close to the front of the rack for better access
第1题:
A. IDF
B. 66 block
C. MDF
D. 110 block
第2题:
A technician needs to manage a switch by using the management port on the back of the switch.Which of the following cables would the technician use?()
第3题:
A.HDMI
B.Optical
C.VGA
D.DVI
第4题:
When installing cables, which of the following is the BEST way of identifying the individual cables?()
第5题:
Which of the following would MOST likely be used to punch down LAN cables before connecting them to the main switch?()
第6题:
A.Ensure that the Ethernet encapsulations match on the interconnected router and switch ports.
B.Ensure that cables A and B are straight-through cables.
C.Ensure cable A is plugged into a trunk port.
D.Ensure the switch has power.
E.Reboot all of the devices.
F.Reseat all cables.
第7题:
An administrator needs to terminate network cables that have just been installed in the main communications closet. Which of the following tools is required?()
第8题:
A.Straight
B.Console
C.Crossover
D.Loopback
第9题:
An end user reports that their computer is not performing as fast as it used to and it shuts down unexpectedly. Which of the following is the MOST likely cause?()
第10题:
The network administrator wants to enable an EtherChannel between two switches in "on" mode. The administrator connects the cables and enables the interfaces, but while configuring the EtherChannel in the first switch,a spanning-tree loop was detected. Which two of these procedures can avoid this problem?()