Move the architecture from 32-bit to 64-bit.
Install a PBX card.
Install a second NIC card.
Install a fail-over cable.
第1题:
A. Move the architecture from 32-bit to 64-bit.
B. Install a PBX card.
C. Install a second NIC card.
D. Install a fail-over cable.
第2题:
A technician needs to install an additional PCI NIC without powering down the server. Which of the following BEST describes the technology the board must support?()
第3题:
An environment has a DC server and an Exchange server. The administrator needs to install a patch and restart both servers while minimizing downtime. Which of the following is the BEST way to restart the servers?()
A. Restart both servers at the same time so the servers are down at the same time.
B. DC server first, then the Exchange server second.
C. The order in which the servers are restarted does not matter.
D. Exchange server first, then the DC server second.
第4题:
An environment has a DC server and an Exchange server. The administrator needs to install apatch and restart both servers while minimizing downtime. Which of the following is the BEST way torestart the servers?()
第5题:
Which of the following expansion cards would be necessary to increase fault tolerance in a VoIP server?()
第6题:
A System p administrator plans to install a new system with AIX 5.3 TL5 using a NIM server. Which of the following provide post install diagnostics()
第7题:
An administrator is receiving too many alerts for processor utilization on a server. Which of the following should the administrator perform?()
第8题:
A. Install a small network switch
B. Use port mirroring on the switch
C. Split the pairs of the existing jack
D. Install a CSU/DSU
第9题:
An administrator attempts to install the latest security patches for an older server. When the administrator runs the patch installer, the install fails. The administrator tries again, and the installer fails again. Which of the following is the MOST likely reason for this?()
第10题:
The administrator has just installed a new memory module into the server. Now, the server is not showing the new memory. Which of the following should the administrator perform FIRST?()