Processor failure
Third party memory
Disk drive failure
ESD during the upgrade
Backplane failure
第1题:
An administrator has shut down a server to install additional memory. When the administrator restarts the server after the upgrade, it times out. Which of the following could be the cause of the problem?()
A. Processor failure
B. Third party memory
C. Disk drive failure
D. ESD during the upgrade
E. Backplane failure
第2题:
An administrator has just upgraded a server from non-hot plug storage to all hot plug storage. The administrator powers up the server, during POST the RAID controller is recognized but none of the drive lights flash. Which of the following should the administrator do FIRST to troubleshoot the problem?()
第3题:
You are the administrator of Ezonexam.com's network.
Ezonexam has several branch offices. Each branch office has a Windows 2000 Server computer with Service Pack 2 installed. Each branch office also has a technical support department. You want to configure the remote Windows 2000 Server computers so that whenever a new driver becomes available from Microsoft, the branch offices are notified automatically when the administrator logs on to the server.
What should you do?
A.Install Windows Update
B.Install the Windows 2000 Resource Kit.
C.Configure System File Checker to notify the branch offices.
D.Configure Window File Protection to notify the branch offices.
第4题:
A technician is responsible for overseeing twelve remote offices. There was a report of a power outage at one of the remote offices the night before, and now one of the servers there has not rebootedeven though it was shut down gracefully. The technician was forced to travel two hours just to turn theserver on. Which of the following is the MOST cost effective way to prevent future travel?()
第5题:
The administrator has just installed a new memory module into the server. Now, the server is not showing the new memory. Which of the following should the administrator perform FIRST?()
第6题:
An administrator has just upgraded a server from non-hot plug storage to all hot plug storage. The administrator powers up the server, during POST the RAID controller is recognized but none of the drive lights flash.Which of the following should the administrator do FIRST to troubleshoot the problem?()
A. Check the backplane cabling.
B. Check the server BIOS.
C. Update the RAID controller firmware.
D. Install the latest hard drive firmware
第7题:
An administrator attempts to install the latest security patches for an older server. When the administrator runs the patch installer, the install fails. The administrator tries again, and the installer fails again. Which of the following is the MOST likely reason for this?()
第8题:
You are the administrator of a network that consists of a single Windows NT 4.0 domain. The network contains five Windows NT Server domain controllers and 1,000 Windows NT Workstation client computers.
You want to install Windows 2000 Server on a new computer. You want the new computer to act as domain controller in the existing domain.
What should you do?
A.On the new computer, install Windows NT Server 4.0 and designate the computer as a BDC in the existing domain. Promote the computer to the PDC of the domain. Upgrade the computer to Windows 2000 Server.
B.On the new computer, install Windows NT Server 4.0 and designate the computer as a PDC in a new domain that has the same NetBIOS name as the existing Windows NT domain. Upgrade the computer to Windows 2000 Server. Use the Active Directory sites and services to force synchronization of the domain controllers.
C.Shut down the PDC of the existing Windows NT domain from the network. On the new computer, install Windows 2000 Server, and then run the Active Directory installation wizard to install Active Directory, specifying the same NetBIOS name for the Windows 2000 domain as the existing Windows NT domain. Restart the Windows NT PDC on the network and demote it to a BDC.
D.Shut down the PDC of the existing Windows NT domain from the network. On the new computer, install Windows 2000 Server, and then run the Active Directory installation wizard to install Active Directory as a replica in the existing Windows NT domain. Promote the new computer to the PDC of the domain. Restart Windows NT PDC on the network and demote it to a BDC.
第9题:
An environment has a DC server and an Exchange server. The administrator needs to install a patch and restart both servers while minimizing downtime. Which of the following is the BEST way to restart the servers?()
第10题:
An administrator has shut down a server to install additional memory. When the administrator restarts the server after the upgrade, it times out. Which of the following could be the cause of the problem?()