多选题Which of the following are both advertised by EIGRP in the Update message and included in the formula for calculating the integer EIGRP metric?（）AJitterBDelayCMTUDReliability

R1 has 5 working interfaces, with EIGRP neighbors existing off each interface. R1 has routes for subnets 10.1.1.0/24, 10.1.2.0/24, and 10.1.3.0/24, with EIGRP integer metrics of roughly 1 million, 2 million, a nd 3 million, respectively. An engineer then adds the ip summary - address eigrp 1 10.1.0.0 255.255.0.0 command to interface Fa0/0.Which of the following is true?（）

A. R1 loses and then reestablishes neighborships with all neighbors.

B. R1 no longer advert ises 10.1.1.0/24 to neighbors connected to Fa0/0.

C. 1 advertises a 10.1.0.0/16 route out Fa0/0, with metric of around 3 million (largest metric of component subnets).

D. R1 advertises a 10.1.0.0/16 route out Fa0/0,with metric of around 2 million (med ian metric of component subnets).

A. router rip

B. router eigrp 10

C. redistribute eigrp 10

D. redistribute rip

E. default - metric 10000 100 255 1 1500

F. default - metric 5

A. It lists a set of path attributes, along with a list of prefixes that use those PAs

B. It lists a prefix/length, plus the PA settings for that prefix

C. It lists withdrawn routes, but never in the same Update message as newly advertised routes

D. A single Update message lists at most a single prefix/lengtH

A. Passiveroutes are in the process of being calculated by DUAL.

B. EIGRP supports VLSM, route summarization, and routing update authentication.

C. EIGRP exchanges full routing table information with neighboring routers with every update.

D. If the feasible successor has a higher advertised distance than the successor route, it becomes the primary route.

E. A query process is used to discover a replacement for a failed route if a feasible successor is not identified from the current routing information.

A.Jitter

B.Delay

C.MTU

D.Reliability

During the redistribution process configured on RTA, some of the EIGRP routes, such as 10.1.1.0/24 and 10.2.2.0/24,are not being redistributed into the OSPF routing domain. Which two items could be a solution to this proble m?（）

A. Change the EIGRP AS number from 100 to1 in the redistribute command.

B. Add the subnets option to the redistribute command.

C. Change the metric - type to2 in the redistribute command.

D. Configure the redistribute command under router eigrp 1 i nstead.

E. Change the metric to an EIGRP compatible metric value (bandwidth, delay, reliability, load, MTUs) in the redistribute command.

A. A change in the load on an interface will cause EIGRP to recalculate the routing metrics and send a corresponding update out to each of its neighbors.

B. EIGRP calculates interface load as a 5 - minute exponentially weighted average that is updated every 5 minutes.

C. EIGRP considers the load of an interface only when sending an update for some other reason.

D. A change in the load on an interface will cause EIGRP to recalculate and update the administrative distance for all routes learne d on that interface.

A. Let the metrics default.

B. Set the metric components using the redistri bute command‘s metric keyword.

C. Set the metric components using the default - metric router subcommand.

D. Set the integer (composite) metric using the redistribute command‘s metric keyword.

Routers R1 and R2, currently EIGRP neighbors over their Fa0/0 interfaces (respectively),both use EIGRP authentication. Tuesday at 8 p.m. the neighborship fails.Which of the following wo uld not be useful when investigating whether authenticationhad anything to do with the failure？（）

A. debug eigrp packet

B. show key chain

C. show ip eigrp neighbor failure

D. show clock