Pull the CMOS battery.
Pull the 20/24 pin connector from the main board.
Short the reset circuit near the RAM.
Use the appropriate jumper on main board.
Use the reset button on the front panel.
第1题:
A. Intrusion detection
B. Power on password
C. Drive encryption
D. BIOS password
第2题:
A. Enable TPM
B. Enable BIOS password
C. Disable TPM
D. Boot sequence
第3题:
A technician turns on a PC and before the computer boots up, the technician is prompted for apassword. The technician does not know the password. Which of the following can the techniciando to allow access to the PC?() (Select TWO).
A. Set the clear password jumper on the motherboard
B. Enter the BIOS setup and select the clear password setting
C. Remove the power cord from the power supply and then plug it back in
D. Power cycle the PC
E. Remove the CMOS battery for 15 minutes
第4题:
A technician would like to load an operating system CD on startup. Which of the following settings would a technician change in the BIOS?()
第5题:
A technician turns on a PC and before the computer boots up, the technician is prompted for apassword. The technician does not know the password. Which of the following can the techniciando to allow access to the PC?() (Select TWO).
第6题:
A. 6-pin PCI connector
B. 24-pin connector
C. Molex connector
D. SATA connector
第7题:
A technician is attempting to get into the BIOS and they are being prompted for a password. Which of the following can clear the BIOS password?()
第8题:
A. Remove the BIOS chip on the PC
B. Re-flash the BIOS
C. Run password cracking software on the users PC
D. Set the password clear jumper on the motherboard
第9题:
A technician is attempting to configure Windows XP Media Center on a desktop from a CD. The message that comes up on the screen says ‘Missing NTLDR press any key to reboot’. Which of the following should the technician do NEXT?()
第10题:
When a user’s computer is first turned on, they see a lock symbol and a blinking cursor. Which of the following was configured in the BIOS to show this?()