JN0-101
单选题Refering to the exhibit, which statement is correct?（）AThe packets have exceeded the time-to-live valueBThere is a loopCThe asterisks indicate a response time outDThe asterisk indicate that the traceroute is completed
题目
The packets have exceeded the time-to-live value
There is a loop
The asterisks indicate a response time out
The asterisk indicate that the traceroute is completed
参考答案和解析
相似问题和答案
第1题：
Click the Exhibit button.In the exhibit, the Compression > Basic > Endpoints page shows an icon of a red "X" under the tunnel status "IN" column. The error message displays, "No Request Received".What does this indicate?（）
A. There are no devices at the remote site.
B. The remote side does not have QoS enabled.
C. The remote side is not configured for compression to this endpoint.
D. The remote side is not configured for decompression to this endpoint.
第2题：
A.Traceroute transmits ICMP echo-request packets.
B.Traceroute transmits UDP packets.
C.Traceroute receives ICMP echo-reply packets.
D.Traceroute receives ICMP port-unreachable packets.
第3题：
A. The packets have exceeded the time-to-live value.
B. There is a loop.
C. The asterisks indicate a response time out.
D. The asterisks indicate that the traceroute is completed.
第4题：
VOIP is being implemented in the Company network and you need to assess the need for QoS. Which of the following network problems would indicate a need to implement QoS features？（）
- A、Mis-routed packets
- B、Excess jitter
- C、Delay of critical traffic
- D、Packet loss due to congestion
- E、Data link layer broadcast storms
- F、FTP connections unsuccessful
正确答案:B,C,D
第5题：
A. The router will prefer the next hop of 172.16.1.1 for packets destined for the 192.168.1.0 network.
B. The router will prefer the next hop of 172.26.1.1 for packets destined for the 192.168.1.0 network.
C. The router will adve rtise the 192.168.1.0 network only to 172.30.1.1.
D. The router will advertise the 192.168.1.0 network only to 172.26.1.1.
E. The router will prefer the next hop of 172.26.1.1 for packets except those destined for the 192.168.1.0 network.
第6题：
A. All routes are accepted.
B. All routes are rejected.
C. A 172.27.0.0/24 route will be accepted.
D. A 172.27.0.0/16 route will be accepted.
第7题：
A. The packets have exceeded the time-to-live value
B. There is a loop
C. The asterisks indicate a response time out
D. The asterisk indicate that the traceroute is completed
第8题：
A. Three physical interfaces are redundant.
B. You must define an additional Redundancy Group.
C. node 0 will immediately become primary in the cluster.
D. You must issue an operational command and reboot the system for the above configuration to take effect.
第9题：
A. RTA will not establish an OSPF adjacency w ith RTB
B. RTA will send OSPF hello packets, but will not send OSPF updates
C. RTA will not accept OSPF hello packets from RTB
D. RTA will send OSPF updates, but will not establish an adjacency with RTB
第10题：
Which statement best describes the rogue AP location display of the WCS wireless management server？ （）
- A、Cisco WCS Base and Cisco WCS Location both indicate rogue AP location only in a Rogue AP Alarm text file
- B、Cisco WCS Base and Cisco WCS Location both indicate rogue AP location in a map at the most probable location that is calculated by two or more APs
- C、Cisco WCS Base identifies the general location of rogue APs based on the signal strength received by the nearest managed Cisco APs， whereas Cisco WCS Location adds high-accuracy location tracking to within a few meters of the rogue AP
- D、Cisco WCS Base does not have this feature， whereas Cisco WCS Location can indicate rogue AP location in a map at the most probable location that is calculated by two or more APs
- E、Cisco WCS Base does not have this feature， whereas Cisco WCS Location can indicate rogue AP location in a map beside the nearest associated AP
正确答案:C