单选题Which smit fastpath should be used to configure Link Aggregation on a server?（）A tcpipB linkAggC failoverD etherchannel

第1题：

Which statement is true regarding the Port Aggregation Protocol？ （）

• A、Configuration changes made on the port-channel interface apply to all physical ports assigned to the portchannel interface.
• B、Configuration changes made on a physical port that is a member of a port-channel interface apply to the port-channel interface.
• C、Configuration changes are not permitted with Port Aggregation Protocol； instead， the standardized Link Aggregation Control Protocol should be used if configuration changes are required.
• D、The physical port must first be disassociated from the port-channel interface before any configuration changes can be made.

第2题：

Which three statements are true of the Link Aggregation Control Protocol （LACP）？（）

• A、LACP is used to connect to non-Cisco devices.
• B、LACP packets are sent with the command channel-group 1 mode desirable.
• C、LACP packets are sent with the command channel-group 1 mode active.
• D、Standby interfaces should be configured with a higher priority.
• E、Standby interfaces should be configured with a lower priority.

第3题：

第4题：

A parallel printer has just been connected. There are not selections in the SMIT menu to configure the printer. Which of the following procedures should be performed to complete the configuration?（）

• A、chdev
• B、reboot
• C、lpstat -Q
• D、smit install

第5题：

Which smit fastpath should be used to configure Link Aggregation on a server?（）

• A、tcpip
• B、linkAgg
• C、failover
• D、etherchannel

第6题：

Which of the following scenarios are likely reasons for an EtherChannel to fail？（）

• A、Mismatched EtherChannel protocol
• B、Mismatched EtherChannel port selection
• C、Mismatched EtherChannel distribution algorithm
• D、Mismatched trunk mode
• E、Mismatched native VLAN
• F、Mismatched link speed

第7题：

On a 3550 EMI switch，  which three types of interfaces can be used to configure HSRP？ （）

• A、 Loopback interface
• B、 SVI interfac
• C、 Routed port
• D、 Access port
• E、 EtherChannel port channel
• F、 BVI interface

第8题：

第9题：

Which fastpath would be used to go directly to commit applied software？（）

• A、 smit commit
• B、 smit install
• C、 smit software
• D、 smit verify_install

第10题：

Which of the following commands should be used to obtain information about the installed software？（）

• A、 smit system
• B、 smit installp
• C、 smit licenses
• D、 smit list_software