Refer to the exhibit. What statement is true base d upon the configuration in the exhibit? ()A. CGMP version 2 is being used.B. The switch will use sparse mode first, dense mode second.C. A rendezvous point must be configured in order for the interface to

Refer to the exhibit. The partial configuration for an OSPF ASBR and an Area 0 ABR is shown. Assume the OSPF configurations throughout the network are operable. Which statement about these configurations is true? （）

A. The ASBR route - maps are basically useless, because there are no deny prefix - lists.

B. LSA Type 5s wil l not be received by the ABR from the ASBR.

C. The OSPF backbone will not learn any RFC 1918 addresses.

D. The matched prefix - list addresses will be given a metric of 255, which is essentially unreachable.

A. Confirm if there are other problematic route - map statements that precede divert.

B. Check the access list for log hits.

C. Check the routing table for 212.50.185.126.

D. Remove any two of the set clauses. (Multiple set clause entries will cause PBR to use the routing table.)

A. BGP NSF awareness is enabled

B. SSO for BGP NSF capability is enabled

C. BGP graceful restart awareness is enabled

D. 10.11.1.187 is configured as an NSF-capable BGP neighbor

A.The router is in area 49.0001.0002

B.The router acts as a Level 1 - 2 router

C.CLNS routing is enable d for the router

D.The router has a system ID of 0003.0004

E.The interfaces have a functional IS - IS configuration

F.The network service access point selector (NSEL) byte has a value of 0

A. Additional DHCP options will be imported from another DHCP server.

B. The DHCP server pools need to be bound to an interface to operate.

C. This configuration will provide IP configuration information to two different su bnets.

D. Additional DCHP option information needs to be imported from another DHCP server.

E. If the router hands out all the addresses in pool 1, then it will supply addresses from pool 2.

Refer to the exhibit. A partial routing configuration is shown. Complete the configuration so that only the default - network is redistributed from EIGRP 190 into EIGRP 212. Which ACL statement completes the configuration correctly? （）

A. access - list 100 permit ip 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0 .0

B. access - list 100 permit ip host 0.0.0.0 any

C. access - list 100 permit ip any host 0.0.0.0

D. A default -network cannot be redistributed between routing processes.

A. DHCP requests from the host will be rebroadcasted to R2.

B. To complete t his configuration, the R1 fa0/0 interface must be configured with the ip helper - addresses command.

C. To complete this configuration, the R2 fa0/0 interface must be configured with the ip helper -addresses command.

D. R1 will forward all DHCP requests t o both 192.168.100.1 and 192.168.200.1 as unicast messages.

E. R1 will forward DHCP requests to 192.168.100.1. If there is no response, R1 will then forward the requests to 192.168.200.1.

Refer to the exhibit. The routing protocols EIGRP and OSPF have been configured as indicated in the exhibit. Given the partial configuration of router R2, which network will be present in th e routing table of R4?（）

A. Network B

B. Network A and Network B

C. Network A

D. neither Network A nor Network B

A. Hosts belonging to DHCP pool 1 and pool 2 will retain their IP settings for 30 hours before they must renew.

B. Hosts will receive IP settings from pool 1 until the addresses run out, and then hosts will receive the settings from pool 2.

C. Hosts in the 10.10.20.0/24 subnet will u se 10.10.20.50 as its DNS server.

D. DHCP pool 0 needs to have the ip dhcp excluded - address command to exclude the default router and DNS servers.

A. Only traffic with a destination from 10.10.0.0/19 will be permitted.

B. Router RAR1 will accept only route 10.10.0.0/19 from its BGP neighbor.

C. Only traffic going to 10.10.0.0/19 will be permitted.

D. Router RAR1 will send only route 10.10.0.0/19 to its BGP neighbor.