As an experienced Network Engineer, you are responsible for network connectivity and system configuration. Which of the following protocols will be supported by Cisco Nonstop Forwarding (NSF)?()
第1题:
What management tool could be used to provide centralized configuration, monitoring, and management in a network built on Cisco wireless LAN controllers and Lightweight APs? ()
第2题:
---Stand by engine! ---Stand by engine!()
第3题:
As an experienced network administrator, you are aware of the knowledge that it is unnecessary to configure complex overlay network topologies while applying Cisco Wide Area Application Services (WAAS) technology.What is most probably the reason for that?()
A. Content pre-positioning
B. Automatic discovery of Cisco WAEs
C. Comprehensive logs, reports, and graphs
D. Remote scheduling of software distribution
第4题:
As an experienced Network Engineer, you are required to implement the security architecture assessment. Which of the following statement describes the most important reason for that?()
第5题:
As an experienced network engineer, you are asked to troubleshoot a CIS network outage. During the troubleshooting process, you notice that one of your colleagues connects additional devices to the network with the use of his own switch. With the purpose of improving speed, the switch is attached to both network ports in an office, which leads to bridge loop. Enabling which of the following feature will be able to prevent this problem from happening again?()
第6题:
HSRP. Known as Hot Stanclby Router Protocol, is a Cisco proprietarv redundancy protocol . As an experienced network administrator, you are required to configure HSRP on a XYZ network. Which TWO of the following wii be available and shared between the routers configured with HSRP? ()(Choose two.)
第7题:
---Ring off engine! ---Ring off engine! ()
第8题:
As a network administrator, you have configured a Catalyst 6500 Series Switch with redundant supervisor engine in a CIS network. What is the result of issuing the redundancy force-switchover command on that switch?()
A. Automatic switchover from active to standby on primary supervisor failure
B. Reset of the primary supervisor.
C. Manual switchover from active to standby supervisor
D. Manual switchover from standby to active supervisor
第9题:
You are an experienced network administrator in an international corporation. One of your clients asks you to configure a network for a financial trading center which requires multiple high-value transactions. And the transactions are very important to the client. In such a situation, which two of the following are basic and most important requirements concerning the configuration? ()(Choose two.)
第10题:
As an experienced Network Engineer, you are required to characterize an existing CIS network. In such a situation, what is the last step to take?()