When installing external SCSI devices， terminators are required on：（）A、 the SCSI adapter.B、 each device.C、 the first device.D、 the last device.E、 the servers parallel port.

第1题：

第2题：

You install a SCSI adapter and a SCSI tape drive on your Windows 2000 Professional computer. You start the computer and Windows 2000 Professional detects and installs drivers for the new SCSI devices. Later the same day, you restart your computer. During the startup process, the computer stops loading Windows 2000 Professional. You then restart the computer and it stops again. You want to enable your Windows 2000 Professional computer to start successfully. What should you do?（）

• A、Start the computer in Safe Mode. Enable driver signing.
• B、Start the computer in Safe Mode. Use Device Manager to remove the SCSI tape device.
• C、Start the computer by using the Recovery Console. Repair the Master Boot Record by using the fixmbr command.
• D、Start the computer by using the Recovery Console. Disable the SCSI adapter device driver by using the disable command.

第3题：

第4题：

Which of the following must occur when installing SCSI devices into the server？（）

• A、 Terminate the back end of the chain.
• B、 Set the jumper to device ID 0.
• C、 Terminate both ends of the chain.
• D、 Set the jumper to cable select.

第5题：

Company.com wants to create four partitions on a pSeries p5-570 8-way with one SCSI PCI adapter connected to an external LTO tape drive. The partitions are to be created from an existing system image backup tape.  Which of the following actions will enable the creation of the partitions with minimal intervention？（）

• A、Install a VIO partition to share the tape drive.
• B、Purchase three external SCSI adapters and physically move the tape drive when needed.
• C、Create the partition definitions with the SCSI adapter as a desired resource and use DLPAR commands to move the tape drive.
• D、Create the partition definitions with the SCSI adapter as a required resource for all partitions and use DLPAR commands to move the tape drive.

第6题：

Which of the following is the number of SCSI devices that can be added to a single narrow SCSI bus?（）

• A、6
• B、7
• C、8
• D、9

第7题：

Companycom is implementing a pair of Virtual IO Servers to service four LPARs. If each operating system image requires 15GB of disk space, what is the minimum amount of SCSI resource necessary?（）

• A、Two SCSI paths and two 73GB SCSI disks
• B、Two SCSI paths and two 36GB SCSI disks
• C、Four SCSI paths and four 73GB SCSI disks
• D、Two dual port SCSI RAID adapters with two 73GB SCSI disks

第8题：

第9题：

What are the two parallel SCSI specifications？（）

• A、 Up to 25 m bus length
• B、 Only one device per SCSI bus
• C、 Up to 16 devices per SCSI bus
• D、 Half-duplex operation
• E、 Full-duplex operation

第10题：

Two new servers are purchased and need to be installed to allow sharing of a single external hard drive enclosure.  One server is configured as a local file server， and the other as a database server for a different network.  The onsite technician notices that when both servers are running at the same time， they each receive SCSI errors. When they are running individually， no errors are reported.   Which of the following is the BEST source of information to use for troubleshooting this problem？（）

• A、 the server vendor’s FAQ website
• B、 the SCSI controller vendor’s user manual
• C、 the drive enclosure vendor’s user manual
• D、 the network operating system vendor’s website