reuse
suppress
half-life
max-suppress-time
第1题:
A. The BGP session does not establish.
B. The hold time is assumed to be infinite.
C. The larger of the two hold-time values is used.
D. The smaller of the two hold-time values is used.
第2题:
In BGP routing,what does the rule of synchronization mean?()
第3题:
A. reuse
B. suppress
C. half-life
D. max-suppress-time
第4题:
SR7750调测BGP邻居状态变化的命令是()
第5题:
You have a router running BGP for the MPLS network and OSPF for the local LAN network at the sales office. A route is being learned from the MPLS network that also exists on the OSPF local network. It is important that the router chooses the local LAN route being learned from the downstream switch running OSPF rather than the upstream BGP neighbor. Also, if the local OSPF route goes away, the BGP route needs to be used. What should be configured to make sure that the router will choose the LAN network as the preferred path?()
第6题:
A. The BGP session to the 10.3.3.3 neighbor is established, but the router has not received any BGP routing updates from the 10.3.3.3 neighbor.
B. The router is attempting to establish a BGP peering session with the 10.2.2.2 neighbor.
C. The router is attempting to establish a BGP peering session with the 10.1.1.1 neighbor.
D. The BGP session to the 10.3.3.3 neighbor is established.
E. The BGP session to the 10.2.2.2 neighbor is established.
F. The BGP session to the 10.1.1.1 neighbor is established.
第7题:
You issue the command show process memory ∣ include BGP and notice that BGP is consuming alarge percentage of the router’s memory. Which of the following steps would result in lowering theamount of memory being consumed by BGP?(Choose all that apply.)()
第8题:
A. upstream EBGP neighbors
B. downstream EBGP neighbors
C. upstream IBGP neighbors learned by IBGP peers
D. downstream IBGP neighbors learned by IBGP peers
第9题:
When BGP is used as the PE-CE routing protocol, which of these statements is correct?()
第10题:
Two routers configured to run BGP have been connected to a firewall, one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer, including the correct BGP session endpoint addresses and the correct BGP session hop-count limit (EBGP multihop). What is a good first test to see if BGP will work across the firewall?()