The Gallant router has the wrong LMI type configured
Inverse ARP is providing the wrong PVC information to the Gallant router
The S3 interface of the Steele router has been configured with the frame-relay encapsulation ietf command
The frame-relay map statement in the Attalla router for the PVC to Steele is not correct
The IP address on the serial interface of the Attalla router is configured incorrectly
第1题:
A. frame-relay arp
B. frame-relay map
C. frame-relay interface-dlci
D. frame-relay lmi-type
E. frame-relay pvc
第2题:
A.show frame-relay end-to-end
B.show frame-relay map
C.show frame-relay lmi
D.show frame-relay pvc
第3题:
A. frame-relay arp
B. frame-relay map
C. frame-relay interface-dlci
D. frame-relay lmi-type
第4题:
In order to troubleshoot an issue with the Testking frame relay network, you log into a remote router via a telnet session and issue the command "debug frame-relay lmi". After a long wait, you fail to see any output. What could be the cause of this problem?()
第5题:
A new frame-relay network is being implemented and inverse ARP does not appear to be operating correctly. Which alternative command can be used to provide connectivity?()
第6题:
A.show frame-relay map
B.show frame-relay lmi
C.show inter serial
D.show frame-relay pvc
第7题:
Which two statements are correct about configuring AutoQoS on a Cisco router? ()
第8题:
A. Router(config-if)# encapsulation frame-relay q933a
B. Router(config-if)# encapsulation frame-relay ansi
C. Router(config-if)# encapsulation frame-relay ietf
D. Router(config-if)# encapsulation frame-relay isl
E. None of the above
第9题:
What does FRTP stand for?()
第10题:
The Frame Relay network in the diagram is not functioning properly. What is the cause of the problem?()