Assign applications to traffic classes.
Use ToS/DSCP values for traffic classes.
Exclude subnets from QoS management.
Select dedicated vs. over-subscribed circuits.
第1题:
A. Setup an ACL that allows and logs all IP traffic between the two computers
B. Configure a spanning tree to check for a loop
C. Setup a span port on the switch to watch for CRC errors
D. Connect both computers using a crossover cable
第2题:
Which of the characteristics below is associated with the (QoS) Integrated Services Model?()
第3题:
A. Assign applications to traffic classes.
B. Use ToS/DSCP values for traffic classes.
C. Exclude subnets from QoS management.
D. Select dedicated vs. over-subscribed circuits.
第4题:
SDM creates a low latency queuing (LLQ) service policy with its associated classes. What are the two types of low latency queuing available using the SDM QoS wizard?()
第5题:
Which statement is true about the SDM QoS wizard and its ability to enable a QoS policy on router interfaces?()
第6题:
Which two statements or sets of statements are true about the application of the qos pre-classify command?()
第7题:
Which statement is correct about the Cisco QoS SDM wizard?()
第8题:
A.A
B.B
C.C
D.D
第9题:
An administrator is troubleshooting a communication issue between two computers on the same Layer 2 switch. Which of the following is the BEST way to determine if the switch is causing the issue?()
第10题:
Which two statements about the QoS policy generation phase of the Cisco SDM QoS wizard are true?()