单选题A technician is unable to eject a tape from a drive when pressing the eject button. Which of the following is MOST likely the cause？（）A Corrupt OSB Array is rebuildingC Driver problemD Drive failure

第1题：

After performing the initial steps in installing the server OS from a DVD-ROM， the server reboots and goes back into the setup wizard. Which of the following is the MOST likely cause for this problem？（）

• A、The DVD-ROM drive has failed.
• B、An installation file copied from the DVD to the hard drive is corrupt.
• C、Faulty OS installation DVD
• D、Incorrect boot sequence in the BIOS

第2题：

A user reports that after configuring the BIOS to boot to the hard drive first, the system still tries to boot from the optical drive. Which of the following is the MOST likely cause?（）

• A、Optical drive
• B、Power supply
• C、CMOS battery
• D、CD-ROM disk

第3题：

第4题：

Bob, a technician, is adding a secondary IDE hard drive to an older system. After installation and the first boot, the drive is not showing in Disk Management. Which of the following is the MOST likely cause of the issue?（）

• A、The new drive’s jumper is set for master.
• B、The new drive is connected to the secondary bus as a slave drive.
• C、Both drives’ jumpers are set for cable select.
• D、The old drive’s jumper is set for master and the new drive is set for slave.

第5题：

A technician is unable to eject a tape from a drive when pressing the eject button. Which of the following is MOST likely the cause？（）

• A、Corrupt OS
• B、Array is rebuilding
• C、Driver problem
• D、Drive failure

第6题：

An operator is asked to rewind and eject a tape from a system. Which command will accomplish this without touching the tape drive?（）

• A、tctl reset
• B、tctl rewind
• C、tctl return
• D、tctl rewoffl

第7题：

A server has a single failed hard drive in an array that is accessed through a hot plug backplane to ease replacement of failed drives. After replacing the drive several times， each of the replacement drives failed to power up and rebuild as the failed drive.  Which of the following is the MOST likely cause of the failures？（）

• A、 The backplane has failed and needs to be replaced.
• B、 The array must be disbanded and recreated from a backup source to recognize the replacement drive.
• C、 There is a conflict with the optical drive on the server.
• D、 The server power supply is failing and not providing enough power for all the drives.

第8题：

第9题：

A technician is troubleshooting a CD/DVD drive. There is a disk in the drive and the tray wont eject. Which of the following actions should the technician take FIRST？ （）

• A、Shutdown， restart and verify that the BIOS recognizes the drive and try again.
• B、Replace the CD/DVD drive.
• C、Pry the tray open with a small， flat head screwdriver.
• D、Place the end of a paper clip in the emergency eject pinhole on the CD/DVD drive.

第10题：

A floppy drive is replaced in a computer and now when the computer is turned on the floppy drive light is constantly lit. Which of the following is the MOST likely cause?（）

• A、The power supply has failed.
• B、The drive cable is connected backwards.
• C、The floppy drive has failed.
• D、The proper drivers have not been loaded.