单选题What must be configured prior to the first commit after factory defaults are loaded?（）A root authenticationB default gatewayC hostnameD management services

第1题：

Which MST configuration statement is correct？  （）

• A、 MST configurations can be propagated to other switches using VTP.
• B、 After MST is configured on a Switch， PVST+ operations will also be enabled by default.
• C、 MST configurations must be manually configured on each switch within the MST region.
• D、 MST configurations only need to be manually configured on the Root Bridge.
• E、 MST configurations are entered using the VLAN Database mode on Cisco Catalyst switches.

第2题：

After factory-defaults have been loaded, which two syslog files will be present in the configuration?（）

• A、system and chassisd
• B、syslog-messages and NVRAM
• C、messages and interactive-commands
• D、authorization and events

第3题：

第4题：

What must be configured prior to the first commit after factory defaults are loaded?（）

• A、root authentication
• B、default gateway
• C、hostname
• D、management services

第5题：

Prior to implementing an LPAR system， which of the following needs to be done？（）

• A、A graphics monitor must be attached to the server
• B、Cluster System Management （CSM） software must be installed
• C、The LPAR system must have an Hardware Management Console （HMC） connected
• D、Each LPAR must be configured with a CDROM for operating system installation

第6题：

When configuring the Cisco VPN Client，what action is required prior to installing Mutual Group Authentication？（）

• A、Transparent tunneling must be enabled.
• B、A valid root certificate must be installed.
• C、A group pre-shared secret must be properly configured.
• D、The option to "Allow Local LAN Access" must be selected.

第7题：

To enable a tty port to be used for a cu session what must be done to the system？（）

• A、smit tty； take the defaults and create the desired tty
• B、In the /etc/uucp Devices add a line similar to： Direct ttyX - 9600 direct
• C、Install bos.net.uucp and the first available tty will be configured for use by a cu session
• D、Run the Asynchronous Terminal Emulation （ATE） program and it will configure a tty port for a cu session

第8题：

第9题：

A client tried to upgrade the system firmware on a p5 590, but it failed. What is the minimum requirement to update the system firmware from the HMC if inventory scout is already installed?（）

• A、A public internet connection
• B、All of the Logical Partitions need to be active
• C、One partition must be configured with Service Authority
• D、A local Repository must be configured prior to the update

第10题：

How can you reset your router or switch to factory defaults?（）

• A、reset configuration
• B、load factory-default
• C、load override default
• D、set default configuration