其他

You have just configured a static default route on router TK1. What is the purpose of a default route?()A. It is a route to be used when the routing protocol fails.B. It is a route configured by an ISP that sends traffic into a corporate network.C. It is

题目
You have just configured a static default route on router TK1. What is the purpose of a default route?()

A. It is a route to be used when the routing protocol fails.

B. It is a route configured by an ISP that sends traffic into a corporate network.

C. It is a route used when a packet is destined for a remote network that is not listed in the routing table.

D. It is a route manually configured for a specific remote network for which a routing protocol is not configured.

E. It is used to send traffic to a stub network.

如果没有搜索结果，请直接 联系老师 获取答案。
如果没有搜索结果，请直接 联系老师 获取答案。
相似问题和答案

第1题：

Which two statements are true regarding route preference?()

A. Lower preference values are more preferred than higher preference values.

B. You can modify the default preference values for any of the routing information sources.

C. By default, a static route is more preferred than a RIP route.

D. A static route is always preferred over a direct route.


参考答案：A, C

第2题：

Refer to the exhibit. R1 accesses the Internet using E0/0. You have been asked to co nfigure R1 so that a default route is generated to its downstream devices (191.0.0.1 and 192.0.0.1). Which commands would create this configuration? （）

A.router eigrp 190redistribute static ! ip route 0.0.0.0 0.0.0.0 Null0

B.ip default - network 2 0.0.0.0

C.router eigrp 190 redistribute static ! ip route 0.0.0.0 255.255.255.255 Null0

D.ip default - network 20.20.20.0


参考答案：A

第3题：

You need to configure a default route on a Ezonexam router. Which command will configure a default route on a router?

A．VE1(config)# ip route 0.0.0.0 10.1.1.0 10.1.1.1

B．VE1(config)# ip default-route 10.1.1.0

C．VE1(config)# ip default-gateway 10.1.1.0

D．VE1(config)# ip route 0.0.0.0 0.0.0.0 10.1.1.1


正确答案：D
解析：Explanation:Thecommand"IProute0.0.0.00.0.0.0<ip-addressoftheinterface>"commandisusedtoconfigureadefaultrouteonarouter.Inthiscase,adefaultroutewithanexthopIPaddressof10.1.1.1wasconfigured.IncorrectAnswers:A.Thiswillbeaninvalidroute,sincethe"10.1.1.0"valuewillspecifythenetworkmask,whichinthiscaseisinvalid.B,C.Thesecommandsareinvalid.Thecommand"ipdefault-network"couldbeused,butnot"ipdefault-route"or"ipdefault-gateway".IPdefault-gatewayisusedonswitches,notrouters.

第4题：

A router learns about a remote network from EIGRP, OSPF, and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network（）。

A.The router will use the static route.

B.The router will use the OSPF route.

C.The router will use the EIGRP route.

D.The router will load balance and use all three routes.


参考答案：A

第5题：

Refer to the exhibit. EIGRP has been configured on all routers in the network. What additional configur ation statement should be included on router R4 to advertise a default route to its neighbors?()

A. R4(config)# ip route 0.0.0.0 0.0.0.0 10.1.1.1

B. R4(config)# ip default - network 10.0.0.0

C. R4(config - router)# default -information originate

D. R4(conf ig)# ip route 10.0.0.0 255.0.0.0 10.1.1.1


参考答案：B

第6题：

What happens when a route does not match any user configured policies?()

A.The route is rejected.

B.The route is accepted.

C.The route is given a lower priority.

D.The route is sent to the default policy.


参考答案：D

第7题：

Which three statements are true about EIGRP route summarization?()

A.When manual summarization is configured, the router immediately creates a route that points to null0 interface

B.Manual route summarization is configured in router configuration mode when the router is configured for EIGRP routing

C.Manual route summarization is configured on the interface

D.The ip summary - address eigrp command generates a default route with an administrative distance of 5

E.When manual summarization is configured, the summary route will use the metric of the largest specific metric of the summary routes

F.The ip summary - address eigrp command generates a default route with an administrative distance of 90


参考答案：A, C, D

第8题：

You can successfully ping a Bridged 1483 customer‘s workstation from the local ERX. However, a remote ERX router in your network cannot ping that same device.What could be causing this problem?()

A. incorrect DSL network redistribution

B. incorrect static host route configuration

C. incorrect static customer route configuration

D. incorrect default static route configuration on the end user


参考答案：A

第9题：

Which of the following commands would you use, to configure a default route to any destination NOT found in the routing table?()

A. Router(config)# ip default-route 0.0.0.0 255.255.255.255 s0

B. Router(config)# ip route 0.0.0.0 255.255.255.255 s0

C. Router(config)# ip default-route 0.0.0.0 0.0.0.0 s0

D. Router(config)# ip route 0.0.0.0 0.0.0.0 s0

E. Router(config)# ip route any any e0


参考答案：D

第10题：

A router learns about a remote network from EIGRP, OSPF, and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network（）。

  • A、The router will use the static route.
  • B、The router will use the OSPF route.
  • C、The router will use the EIGRP route.
  • D、The router will load balance and use all three routes.

正确答案:A

更多相关问题
相关内容